Department of Transportation 2015 – Federal Register Recent Federal Regulation Documents

These special conditions are issued for the Cirrus Design Corporation SF50 airplane. This airplane will have a novel or unusual design feature(s) associated with the use of an electronic engine control system instead of a traditional mechanical control system. The applicable airworthiness regulations do not contain adequate or appropriate safety standards for this design feature. These special conditions contain the additional safety standards that the Administrator considers necessary to establish a level of safety equivalent to that established by the existing airworthiness standards.

The FAA is issuing this notice to advise the public of the Sixteenth Special Committee 227 meeting.

The FAA is issuing this notice to advise the public of the twenty-fourth Special Committee 214 meeting.

We are superseding Airworthiness Directive (AD) 2011-19-04, for all Airbus Model A318, A319, A320, and A321 series airplanes. AD 2011-19-04 required repetitive inspections for cracking of the left- hand and right-hand inboard and outboard elevator servo-control rod eye-ends, and corrective actions if necessary. This new AD requires an inspection to determine if certain elevator servo-control parts are installed, and replacement if necessary. This AD was prompted by a determination that certain elevator servo-control parts that do not conform to the approved type design have been installed and may have the potential of cracks in the rod eye-end. We are issuing this AD to detect and correct rod eye-end cracking, which could result in uncontrolled elevator surface and consequent reduced control of the airplane.

We are revising an earlier proposed airworthiness directive (AD) for all Airbus Model A318, A319, A320, and A321 series airplanes. The NPRM proposed to supersede Airworthiness Directives (AD) 2011-13-11 and AD 2013-16-09. AD 2011-13-11 currently requires an amendment of the airplane flight manual (AFM), repetitive checks of specific centralized fault display system (CFDS) messages, an inspection of the opening sequence of the main landing gear (MLG) door actuator for discrepancies if certain messages are found, and corrective actions if necessary. AD 2013-16-09 currently requires an inspection to determine airplane configuration and part numbers of the landing gear control interface unit and MLG door actuators; and, for affected airplanes, repetitive inspections of the opening sequence of the MLG door actuator, and replacement of the MLG door actuator if necessary; and provides optional terminating action for the repetitive inspections. The NPRM was prompted by a determination that the interval of the MLG door opening sequence inspection must be reduced. The NPRM proposed to reduce the interval of the MLG door opening sequence inspection, and also to replace or modify certain MLG door actuators. This action revises the NPRM by adding a flushing procedure to be performed when installing a new MLG door actuator. We are proposing this supplemental NPRM (SNPRM) to detect and correct deterioration of the damping ring and associated retaining ring of the MLG door actuator, which can sufficiently increase the friction inside the actuator to restrict opening of the MLG door by gravity, during operation of the landing gear alternate (free-fall) extension system. This condition could prevent the full extension and/or down-locking of the MLG, possibly resulting in MLG collapse during landing and consequent damage to the airplane and injury to occupants. Since these actions impose an additional burden over those proposed in the NPRM, we are reopening the comment period to allow the public the chance to comment on these proposed changes.

In accordance with the Paperwork Reduction Act of 1995 and its implementing regulations, the Federal Railroad Administration (FRA) hereby announces that it is seeking renewal of the following currently approved information collection activities. Before submitting these information collection requirements for clearance by the Office of Management and Budget (OMB), FRA is soliciting public comment on specific aspects of the activities identified below.

FMCSA announces its decision to grant requests from 9 individuals for exemptions from the regulatory requirement that interstate commercial motor vehicle (CMV) drivers have ``no established medical history or clinical diagnosis of epilepsy or any other condition which is likely to cause loss of consciousness or any loss of ability to control a CMV.'' The regulation and the associated advisory criteria published in the Code of Federal Regulations as the ``Instructions for Performing and Recording Physical Examinations'' have resulted in numerous drivers being prohibited from operating CMVs in interstate commerce based on the fact that they have had one or more seizures and are taking anti-seizure medication, rather than an individual analysis of their circumstances by a qualified medical examiner. The Agency concluded that granting exemptions for these CMV drivers will provide a level of safety that is equivalent to or greater than the level of safety maintained without the exemptions. FMCSA grants exemptions that will allow these 9 individuals to operate CMVs in interstate commerce for a 2-year period. The exemptions preempt State laws and regulations and may be renewed.

FMCSA announces its decision to grant requests from 6 individuals for exemptions from the regulatory requirement that interstate commercial motor vehicle (CMV) drivers have ``no established medical history or clinical diagnosis of epilepsy or any other condition which is likely to cause loss of consciousness or any loss of ability to control a CMV.'' The regulation and the associated advisory criteria published in the Code of Federal Regulations as the ``Instructions for Performing and Recording Physical Examinations'' have resulted in numerous drivers being prohibited from operating CMVs in interstate commerce based on the fact that they have had one or more seizures and are taking anti-seizure medication, rather than an individual analysis of their circumstances by a qualified medical examiner. The Agency concluded that granting exemptions for these CMV drivers will provide a level of safety that is equivalent to or greater than the level of safety maintained without the exemptions. FMCSA grants exemptions that will allow these 6 individuals to operate CMVs in interstate commerce for a 2-year period. The exemptions preempt State laws and regulations and may be renewed.

FMCSA announces its decision to grant requests from 10 individuals for exemptions from the Agency's physical qualifications standard concerning hearing for interstate drivers. The current regulation prohibits hearing impaired individuals from operating CMVs in interstate commerce. After notice and opportunity for public comment, the Agency concluded that granting exemptions for these drivers to operate property-carrying CMVs will provide a level of safety that is equivalent to or greater than the level of safety maintained without the exemptions. The exemptions are valid for a 2- year period and may be renewed, and the exemptions preempt State laws and regulations.

In accordance with the Paperwork Reduction Act of 1995, FMCSA announces its plan to submit the Information Collection Request (ICR) described below to the Office of Management and Budget (OMB) for its review and approval. The FMCSA requests approval to extend an ICR titled, ``Transportation of Household Goods; Consumer Protection.'' The information collected will be used to help regulate motor carriers transporting household goods (HHG) for individual shippers. FMCSA invites public comment on the ICR.

NHTSA is proposing a rule prescribing procedures for the assessment of civil penalties and for interpreting the factors for determining the amount of a civil penalty or the amount of a compromise under the National Traffic and Motor Vehicle Safety Act (Safety Act), to implement the Moving Ahead for Progress in the 21st Century Act (MAP-21). MAP-21 states that the Secretary of Transportation shall determine the amount of civil penalty or compromise under the Safety Act. MAP-21 identifies mandatory factors that the Secretary must consider and discretionary factors for the Secretary to consider as appropriate in making such determinations. MAP-21 further directs NHTSA to issue a rule providing an interpretation of these penalty factors. NHTSA is also proposing to update our regulations to conform it to the statutory civil penalty maximums enacted in MAP-21, the increased penalties and damages for odometer fraud, and the statutory penalty for knowingly and willfully submitting materially false or misleading information to the Secretary after certifying the same information as accurate.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

Pursuant to Section 10(a)(2) of the Federal Advisory Committee Act (Pub. L. 92-463, 5 U.S.C. App. 2), notice is hereby given of a meeting of the Commercial Space Transportation Advisory Committee (COMSTAC). The meeting will take place on Tuesday, October 20, 2015, from 8:00 a.m. to 5:00 p.m., and Wednesday, October 21, 2015, from 8:30 a.m. to 4:30 p.m. at the National Transportation Safety Board Conference Center, 429 L'Enfant Plaza SW., Washington, DC 20594. This will be the 61st meeting of the COMSTAC. The proposed schedule for the COMSTAC working group meetings on October 20 is below:

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

We are revising an earlier proposed airworthiness directive (AD) that proposed to supersede AD 2006-22-15 for all The Boeing Company Model 747-100, 747-100B, 747-100B SUD, 747-200B, 747-200C, 747- 200F, 747-300, 747-400, 747-400D, 747-400F, 747SR, and 747SP series airplanes. AD 2006-22-15 requires repetitive inspections for cracking of certain panel webs and stiffeners of the nose wheel well (NWW), and corrective actions if necessary; and replacement of certain panels with new panels, which terminates the repetitive inspections. The notice of proposed rulemaking (NPRM) proposed to reduce a compliance time and add certain inspections and applicable repair. The NPRM was prompted by reports of fatigue cracking in the panel webs and stiffeners of the NWW found prior to the inspection threshold of AD 2006-22-15. This action revises the NPRM by specifying a repetitive inspection interval for a certain NWW area inspection. We are proposing this SNPRM to prevent fatigue cracking of the NWW side and top panels, which could result in a NWW depressurization event severe enough to reduce the structural integrity of the fuselage. Since these actions impose an additional burden over that proposed in the NPRM, we are reopening the comment period to allow the public the chance to comment on these proposed changes.

We propose to adopt a new airworthiness directive (AD) for all Fokker Services B.V. Model F.27 Mark 200, 300, 400, 500, 600, and 700 airplanes. This proposed AD was prompted by a design review conducted by Fokker Services B.V. that indicated no controlled bonding provisions were present on many critical locations outside the fuel tank or connected to the fuel tank wall. This proposed AD would require installing the additional bonding provisions, and revising the maintenance or inspection program, as applicable, by incorporating fuel airworthiness limitation items and critical design configuration control limitations. We are proposing this AD to prevent an ignition source in the fuel tank vapor space, which could result in a fuel tank explosion and consequent loss of the airplane.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

As authorized by 46 U.S.C. 12121, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.-build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below.

In compliance with the Paperwork Reduction Act of 1995 (44 U.S.C. 3501 et seq.), this notice announces that the Information Collection Request (ICR) abstracted below is being submitted to the Office of Management and Budget (OMB) for review and comments.