Department of Transportation October 28, 2015 – Federal Register Recent Federal Regulation Documents
Results 1 - 5 of 5
Agency Information Collection Activities: Requests for Comments; Clearance of Renewed Approval of Information Collection: Specific Release Form
In accordance with the Paperwork Reduction Act of 1995, FAA invites public comments about our intention to request the Office of Management and Budget (OMB) approval to renew an information collection. The information garnered from a Specific Release form will be used by FAA Special Agents to obtain information related to a specific investigation. That information is then provided to the FAA decision making authority to make FAA employment and/or pilot certification/revocation determinations.
Airworthiness Directives; The Boeing Company Airplanes
We are superseding Airworthiness Directive (AD) 2015-16-01 for certain The Boeing Company Model airplanes. AD 2015-16-01 required incorporating design changes to improve the reliability of the cabin altitude warning system by installing a redundant cabin altitude pressure switch, replacing the aural warning module (AWM) with a new or reworked AWM, and changing certain wire bundles or connecting certain previously capped and stowed wires as necessary. For certain airplanes, AD 2015-16-01 also required prior or concurrent incorporation of related design changes by modifying the instrument panels, installing light assemblies, modifying the wire bundles, and installing a new circuit breaker, as necessary. This AD retains all actions required by AD 2015-16-01. This AD was prompted by the discovery of a typographical error in AD 2015-16-01 that referred to a nonexistent paragraph. We are issuing this AD to prevent the loss of cabin altitude warning, which could delay flightcrew recognition of a lack of cabin pressurization, and could result in incapacitation of the flightcrew due to hypoxia (a lack of oxygen in the body), and consequent loss of control of the airplane.
Airworthiness Directives; The Boeing Company Airplanes
We are adopting a new airworthiness directive (AD) for certain The Boeing Company Model 737-100, -200, -200C, -300, -400, and -500 series airplanes. This AD requires repetitive eddy current inspections for any cracking in the inspar upper skin, and related investigative and corrective actions if necessary. This AD was prompted by a report that an operator discovered a crack in a certain section of the inspar upper skin, just forward of the rear spar on the right wing. We are issuing this AD to detect and correct any cracking in the inspar upper skin and rear spar upper chord, which could result in the inability of the structure to carry limit load, or result in a fuel leak, which could prevent continued safe flight and landing.
Airworthiness Directives; Rolls-Royce plc Turbofan Engines
We are adopting a new airworthiness directive (AD) for all Rolls-Royce plc (RR) RB211-535E4-37, RB211-535E4-B-37, and RB211-535E4- C-37 turbofan engines. This AD requires reducing the cyclic life limits for certain high-pressure turbine (HPT) disks, removing those disks that have exceeded the new life limit, and replacing them with serviceable parts. This AD was prompted by RR updating the life limits for certain HPT disks. We are issuing this AD to prevent failure of the HPT disk, which could result in uncontained disk release, damage to the engine, and damage to the airplane.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
