Department of Transportation October 29, 2009 – Federal Register Recent Federal Regulation Documents

Pipeline Safety: Pipeline Damage Prevention Programs
Document Number: E9-26099
Type: Proposed Rule
Date: 2009-10-29
Agency: Pipeline and Hazardous Materials Safety Administration, Department of Transportation
This Advance Notice of Proposed Rulemaking (ANPRM) initiates a rulemaking procedure to establish criteria for determining adequate state enforcement of pipeline damage prevention laws. Under the Pipeline Inspection, Protection, Safety, and Enforcement (PIPES) Act of 2006, establishment of these criteria is a prerequisite should PHMSA find it necessary to conduct an enforcement proceeding against an excavator for violation of one-call damage prevention laws in the absence of enforcement action by the state where the events occurred. This notice is issued to solicit feedback and comments regarding the criteria and procedures PHMSA should use to determine if a state's enforcement of its damage prevention laws is adequate. These procedures will encourage states to develop effective excavation damage prevention enforcement programs to protect gas and hazardous liquid pipelines, but also allow federal enforcement authority should any state fail to do so.
Environmental Impact Statement for the Altamont Corridor Rail Project From Stockton to San Jose, CA
Document Number: E9-26098
Type: Notice
Date: 2009-10-29
Agency: Federal Railroad Administration, Department of Transportation
FRA is issuing this Notice to advise other agencies and the public that FRA and the California High-Speed Rail Authority (Authority) will be preparing an Environmental Impact Report/ Environmental Impact Statement (EIR/EIS) for the Altamont Corridor Rail Project proposed by the Authority and the San Joaquin Regional Rail Commission (SJRRC) from Stockton to San Jose via the Altamont Pass and Tri Valley area, connecting the Northern San Joaquin Valley and the San Francisco Bay Area. The Authority and SJRRC are proposing to develop a dedicated regional rail corridor through the Altamont Pass and the Tri Valley area capable of supporting intercity and commuter rail passenger services. The project EIR/EIS will be prepared in compliance with relevant Federal and State laws, in particular the National Environmental Policy Act (NEPA) and the California Environmental Quality Act (CEQA). The Federal Transit Administration (FTA) will serve as a cooperating agency for the preparation of the EIR/EIS.
Proposed Modification of Class E Airspace; Grand Junction, CO
Document Number: E9-26096
Type: Proposed Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
This action proposes to modify Class E airspace at Grand Junction Regional, Grand Junction, CO. Additional controlled airspace is necessary to facilitate vectoring of Instrument Flight Rules (IFR) traffic from Grand Junction Regional, Grand Junction, CO to en route. The FAA is proposing this action to enhance the safety and management of aircraft operations at Grand Junction Regional, Grand Junction, CO. This action also would update the airport name from Grand Junction, Walker Field.
Aviation Proceedings, Agreements Filed the Week Ending October 10, 2009
Document Number: E9-26066
Type: Notice
Date: 2009-10-29
Agency: Office of the Secretary, Department of Transportation
Qualification of Drivers; Exemption Applications; Diabetes
Document Number: E9-26004
Type: Notice
Date: 2009-10-29
Agency: Federal Motor Carrier Safety Administration, Department of Transportation
FMCSA announces receipt of applications from 41 individuals for exemptions from the prohibition against persons with insulin- treated diabetes mellitus (ITDM) operating commercial motor vehicles (CMVs) in interstate commerce. If granted, the exemptions would enable these individuals with ITDM to operate commercial motor vehicles in interstate commerce.
Airworthiness Directives; Rolls-Royce Deutschland Ltd & Co KG Model BR700-715A1-30, BR700-715B1-30, and BR700-715C1-30 Turbofan Engines
Document Number: E9-25942
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Bombardier Model CL-600-2C10 (Regional Jet Series 700, 701 & 702) Airplanes, Model CL-600-2D15 (Regional Jet Series 705) Airplanes, and Model CL-600-2D24 (Regional Jet Series 900) Airplanes
Document Number: E9-25917
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Boeing Model 767-200, -300, -300F, and -400ER Series Airplanes
Document Number: E9-25916
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Boeing Model 767-200, -300, -300F, and -400ER series airplanes. This AD requires an inspection to determine if certain motor operated valve actuators for the fuel tanks are installed, and related investigative and corrective actions if necessary. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to prevent an ignition source inside the fuel tanks, which, in combination with flammable fuel vapors, could result in a fuel tank explosion and consequent loss of the airplane.
Notice of Availability of the Record of Decision for the Final Environmental Impact Statement and the Alaska National Interest Lands Conservation Act Section 810 Analysis of Impacts to Subsistence Resources for Proposed Improvement Activities at the Sitka Rocky Gutierrez Airport, Sitka, AK
Document Number: E9-25834
Type: Notice
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
The Federal Aviation Administration (FAA) is publishing this notice to advise the public that the FAA has issued a Record of Decision (ROD) for the Final Environmental Impact Statement (Final EIS) and Alaska National Interest Lands Conservation Act (ANILCA) Section 810 Evaluation for Proposed Improvement Activities at the Sitka Rocky Gutierrez Airport (SIT) on September 28, 2009. The ROD provides final agency determinations and approvals for the proposed airport improvement activities.
Airworthiness Directives; Boeing Model 747 Airplanes; and Boeing Model 757-200, -200PF, and -300 Series Airplanes
Document Number: E9-25666
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Boeing Model 747 airplanes and certain Boeing Model 757-200, -200PF, and -300 series airplanes. This AD requires replacing the control switches of the forward, aft, and nose cargo doors of Model 747 airplanes; and requires replacing the control switches of cargo doors 1 and 2 of Model 757 series airplanes. This AD results from reports of problems associated with the uncommanded operation of cargo doors. We are issuing this AD to prevent injuries to persons and damage to the airplane and equipment.
Airworthiness Directives; Saab AB, Saab Aerosystems Model SAAB 2000 Airplanes
Document Number: E9-25660
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; Bombardier Model CL-600-2C10 (Regional Jet Series 700, 701 & 702), CL-600-2D15 (Regional Jet Series 705), and CL-600-2D24 (Regional Jet Series 900) Airplanes
Document Number: E9-25648
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; American Champion Aircraft Corp. Models 7ECA, 7GCAA, 7GCBC, 7KCAB, 8KCAB, and 8GCBC Airplanes
Document Number: E9-25258
Type: Rule
Date: 2009-10-29
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for all American Champion Aircraft Corp. Models 7ECA, 7GCAA, 7GCBC, 7KCAB, 8KCAB, and 8GCBC airplanes, manufactured prior to 1989 and equipped with folding rear seat backs. This AD requires inspection of the rear seat back hinge areas for cracking and excessive elongation of the rear seat hinge bolt hole and, if cracking or excessive elongation is found, replacement of the rear seat frame. We are issuing this AD to detect and correct cracking of the rear seat back hinge area and excessive elongation of the rear seat hinge bolt hole, either of which could result in failure of the seat back. This failure could lead to a rear- seated pilot or passenger inadvertently interfering with the control stick while attempting to not roll to the rear of the airplane upon seat back failure. Consequently, this failure could result in loss of control.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.