Department of Transportation June 11, 2009 – Federal Register Recent Federal Regulation Documents

We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by the aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is adopting a new airworthiness directive (AD) for all Boeing Model 747 airplanes. This AD requires inspecting for cracks in the left- and right-side Stringer 11 longeron adjacent to the horizontal stabilizer pivot bulkhead, and related investigative and corrective actions if necessary. This AD results from a report of a crack found in the right-side Stringer 11 longeron horizontal flange, adjacent to the horizontal stabilizer pivot bulkhead, during a routine maintenance inspection. We are issuing this AD to detect and correct fatigue cracking of the longeron, which can propagate and cause damage to the adjacent horizontal stabilizer pivot bulkhead. This damage could result in loss of structural integrity and consequent inability of the bulkhead to carry flight loads, which could adversely affect controllability of the airplane.

We are adopting a new airworthiness directive (AD) for certain Boeing Model 737-300, -400, -500, -600, -700, -700C, -800, and -900 series airplanes. This AD requires installing a new circuit breaker, relays, and wiring to allow the flightcrew to turn off electrical power to the in-flight entertainment (IFE) systems and other non-essential electrical systems through a switch in the flight compartment, and doing other specified actions. This AD results from an IFE systems review. We are issuing this AD to ensure that the flightcrew is able to turn off electrical power to IFE systems and other non-essential electrical systems through a switch in the flight compartment. The flightcrew's inability to turn off power to IFE systems and other non- essential electrical systems during a non-normal or emergency situation could result in the inability to control smoke or fumes in the airplane flight deck or cabin.

We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:

The FAA is adopting a new airworthiness directive (AD) for Rolls-Royce Corporation (RRC) AE 2100D2, AE 2100D2A, AE 2100D3, and AE 2100J turboprop engines with certain propeller gearbox (PGB) shaft-and- carrier assemblies installed. These engines are U.S. type-certificated but as of the effective date of this AD are only installed on military airplanes. This AD requires monitoring a certain population of PGB shaft-and-carrier assemblies for vibration during flight, and borescope-inspecting the PGB shaft for cracks if vibration is experienced. This AD would also require removing the affected population of PGB shaft-and-carrier assemblies from service and installing serviceable PGB shaft-and-carrier assemblies. This AD results from a report of a crack found in the forward cone of a PGB shaft in an RRC AE 2100D3 turboprop engine that was removed from service due to high vibration. We are issuing this AD to prevent separation of the propeller from the airplane, which could result in injury, and damage to the airplane.