Department of Transportation November 29, 2007 – Federal Register Recent Federal Regulation Documents
Results 1 - 12 of 12
IFR Altitudes; Miscellaneous Amendments
This amendment adopts miscellaneous amendments to the required IFR (instrument flight rules) altitudes and changeover points for certain Federal airways, jet routes, or direct routes for which a minimum or maximum en route authorized IFR altitude is prescribed. This regulatory action is needed because of changes occurring in the National Airspace System. These changes are designed to provide for the safe and efficient use of the navigable airspace under instrument conditions in the affected areas.
Proposed Establishment of Low Altitude Area Navigation Routes (T-Routes); St. Louis, MO
This action proposes to establish two low altitude Area Navigation (RNAV) routes, designated T-251 and T-272, in the St. Louis, MO, terminal area. T-routes are low altitude Air Traffic Service routes, based on RNAV, for use by aircraft that have instrument flight rules (IFR) approved Global Positioning System (GPS)/Global Navigation Satellite System (GNSS) equipment. The FAA is proposing this action to enhance safety and improve the efficient use of the navigable airspace in the St. Louis, MO, terminal area.
Proposed Modification of Class E Airspace; Hollister, CA
This action proposes to modify the Class E airspace area at Hollister, CA. Establishment of an Area Navigation (RNAV) Global Positioning System (GPS) Standard Instrument Approach Procedure (SIAP) at Hollister Municipal Airport, Hollister, CA, has made this proposal necessary. Additional controlled airspace is needed for the safety and management of aircraft executing the new RNAV (GPS) SIAPs at Hollister Municipal Airport, Hollister, CA.
Information Collection Available for Public Comments and Recommendations
In accordance with the Paperwork Reduction Act of 1995, this notice announces the Maritime Administration's (MARAD's) intention to request extension of approval for three years of a currently approved information collection.
Canadian National Railway Company and Grand Trunk Corporation-Control-EJ&E West Company 1
The Surface Transportation Board (Board) is accepting for consideration the primary application filed October 30, 2007, by Canadian National Railway Corporation (CNR) and Grand Trunk Corporation (GTC), a noncarrier holding company through which CNR controls its U.S. rail subsidiaries, and seven related filings. The primary application seeks Board approval under 49 U.S.C. 11321-26 of the acquisition of control of EJ&E West Company (EJ&EW), a wholly owned noncarrier subsidiary of Elgin, Joliet and Eastern Railway Company (EJ&E), by CNR and GTC. This proposal is referred to as the Control Transaction, and CNR and GTC are referred to collectively as applicants. The related filings are notices of exemption involving an intra- corporate family transaction and the granting of trackage rights. The Sub-No. 1 filing provides for EJ&E to transfer property to EJ&EW, which, at that time, would become a rail common carrier, prior to applicants acquiring control of EJ&EW. The Sub-Nos. 2 through 7 filings provide for grants of trackage rights by EJ&EW to Grand Trunk Western Railroad (GTW), Illinois Central Railroad Company (IC), Chicago, Central & Pacific Railroad Company (CCP), and Wisconsin Central Ltd. (WCL), and by IC and CCP to EJ&EW, promptly upon applicants' acquisition of control of EJ&EW, should the Board approve the proposed Control Transaction. The Board finds that the Control Transaction is a ``minor transaction'' under 49 CFR 1180.2(c), and adopts a procedural schedule for consideration of the application. In finding that the transaction is a minor transaction, the Board has preliminarily determined that any anticompetitive effects of the transaction will clearly be outweighed by the transaction's anticipated contribution to the public interest in meeting significant transportation needs. 49 CFR 1180.2(b)(2). The Board makes this determination based solely on evidence presented in the application. The Board stresses that this is not a final determination, and its finding may be rebutted by filings and evidence submitted into the record for this proceeding. The Board will give careful consideration to any claims that the transaction will have anticompetitive effects that are not apparent from the application itself. Moreover, the Board has determined to prepare an Environmental Impact Statement (EIS) with respect to the transaction.
Canadian Pacific Railway Company, et al.-Control-Dakota, Minnesota & Eastern Railroad Corp., et al.
The Surface Transportation Board (Board) invites public comments on a proposed procedural schedule for this proceeding. On October 5, 2007, Canadian Pacific Railway Corporation (CPRC), Soo Line Holding Company, a Delaware Corporation and indirect subsidiary of CPRC (Soo Holding), Dakota, Minnesota & Eastern Railroad Corporation (DM&E), and Iowa, Chicago & Eastern Railroad Corporation, a wholly-owned rail subsidiary of DM&E (IC&E) (collectively referred to as the ``Applicants'') submitted a filing with the Board seeking approval under 49 U.S.C. 11321-26 of the acquisition of control of DM&E and IC&E by Soo Holding (and, indirectly, by CPRC). In Decision No. 2, served on November 2, 2007, and published in the Federal Register at 72 FR 63232- 36 on November 8, 2007, the Board accepted the October 5 submission as a prefiling notification, thus allowing the Applicants to perfect their application, and provide any supplemental materials or information, on or after December 5, 2007.\1\
Airworthiness Directives; Hartzell Propeller Inc. Model HC-E5N-3( ), HC-E5N-3( )(L), and HC-E5B-5( ) Propellers
The FAA is adopting a new airworthiness directive (AD) for Hartzell Propeller Inc. Model HC-E5N-3( ), HC-E5N-3( )(L), and HC-E5B- 5( ) propellers. This AD requires a onetime eddy current inspection of the propeller hub mounting bolt holes and replacement of the propeller hub if cracked. This AD results from the discovery of a five-bladed propeller hub with a large crack on the mounting flange of the hub. We are issuing this AD to prevent propeller hub failure, blade separation, damage to the airplane, and possible loss of airplane control.
Airworthiness Directives; Cirrus Design Corporation Model SR22 Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain Cirrus Design Corporation (Cirrus) Model SR22 airplanes. This AD requires you to install a drain hole in the left and right outboard wing tips. This AD results from reports of pilots' inability to move the aileron control without using excessive force when flying in freezing conditions. Moisture from a prior rain shower entered through a gap at the interface of the left and right outboard wing tips and wing structure. The moisture traveled along the aft wing shear web, accumulated below the aileron control pulley, and froze at an altitude with an outside air temperature below freezing. When this moisture is exposed to freezing conditions, operation of the aileron control pulley is impaired. We are issuing this AD to prevent moisture from accumulating along the wing shear web where it may freeze in certain conditions. This condition could result in operational failure of the aileron control pulley, which could lead to loss of control.
Airworthiness Directives; Turbomeca Arriel 2S1 and 2S2 Turboshaft Engines
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) provided by the European Aviation Safety Agency (EASA) to identify and correct an unsafe condition on Turbomeca Arriel 2S1 and 2S2 turboshaft engines. The MCAI states the following:
Airworthiness Directives; Rolls-Royce plc, RB211 Trent 768-60, 772-60, and 772B-60 Turbofan Engines
The FAA is superseding an existing airworthiness directive (AD) for Rolls-Royce plc (RR) RB211 Trent 768-60, 772-60, and 772B-60 turbofan engines. That AD currently requires initial and repetitive on- wing or in-shop inspections of the high pressure/intermediate pressure (HP/IP) turbine bearing oil feed tube heat shield. This AD requires the same actions but introduces a terminating action to the repetitive inspections. This AD results from RR introducing a revised HP/IP turbine bearing support structure as terminating action to the repetitive inspections of the HP/IP turbine bearing oil feed tube heat shield. We are issuing this AD to prevent an uncontained failure of the HP turbine disc and damage to the airplane.
Airworthiness Directives; GROB-WERKE GMBH & CO KG Models G102 CLUB ASTIR III, G102 CLUB ASTIR IIIb, and G102 STANDARD ASTIR III Gliders
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Noise Compatibility Program Notice Baton Rouge Metropolitan Airport, Ryan Field, Baton Rouge, LA
The Federal Aviation Administration (FAA) announces its findings on the noise compatibility program submitted by the Greater Baton Rouge Airport District under the provisions of 49 U.S.C. (the Aviation Safety and Noise Abatement Act, hereinafter referred to as ``the Act'') and 14 CFR part 150. These findings are made in recognition of the description of Federal and nonfederal responsibilities in Senate Report No. 96-52 (1980). On July 30, 2007, the FAA determined that the noise exposure maps submitted by the Greater Baton Rouge Airport District under part 150 were in compliance with applicable requirements. On November 13, 2007, the FAA approved the Baton Rouge Metropolitan Airport, Ryan Field noise compatibility program. Most of the recommendations of the program were approved. No program elements relating to new or revised flight procedures for noise abatement were proposed by the airport operator.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
