Department of Transportation March 16, 2007 – Federal Register Recent Federal Regulation Documents
Results 1 - 20 of 20
Airworthiness Directives; Saab Model SAAB 2000 Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; DORNIER LUFTFAHRT GmbH Models Dornier 228-100, Dornier 228-101, Dornier 228-200, Dornier 228-201, Dornier 228-202, and Dornier 228-212 Airplanes
We propose to adopt a new airworthiness directive (AD) for the products listed above. This proposed AD results from mandatory continuing airworthiness information (MCAI) originated by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Qualification of Drivers; Exemption Applications; Vision
FMCSA announces receipt of applications from 21 individuals for exemptions from the vision requirement in the Federal Motor Carrier Safety Regulations. If granted, the exemptions would enable these individuals to qualify as drivers of commercial motor vehicles (CMVs) in interstate commerce without meeting the Federal vision standard.
Qualification of Drivers; Exemption Applications; Vision
FMCSA announces its decision to renew the exemptions from the vision requirement in the Federal Motor Carrier Safety Regulations for 12 individuals. FMCSA has statutory authority to exempt individuals from the vision requirement if the exemptions granted will not compromise safety. The Agency has concluded that granting these exemptions will provide a level of safety that will be equivalent to, or greater than, the level of safety maintained without the exemptions for these commercial motor vehicle (CMV) drivers.
Qualification of Drivers; Exemption Applications; Diabetes
FMCSA announces receipt of applications from 74 individuals for exemptions from the prohibition against persons with insulin- treated diabetes mellitus (ITDM) operating commercial motor vehicles (CMVs) in interstate commerce. If granted, the exemptions would enable these individuals with ITDM to operate CMVs in interstate commerce.
Requested Administrative Waiver of the Coastwise Trade Laws
As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2007-27551 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.
Requested Administrative Waiver of the Coastwise Trade Laws
As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket MARAD-2007-27550 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S.-vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.
Information Collection Available for Public Comments and Recommendations
In accordance with the Paperwork Reduction Act of 1995, this notice announces the Maritime Administration's (MARAD's) intention to request extension of approval for three years of a currently approved information collection.
Airworthiness Directives; Airbus Model A330 Airplanes
The FAA is superseding an existing airworthiness directive (AD), which applies to certain Airbus Model A330-300 airplanes. That AD currently requires reinforcement of the structure of the center fuselage by installing external stiffeners (butt straps) at frame (FR) 53.3 on the fuselage skin between left-hand (LH) and right-hand (RH) stringer (STR) 13, and related investigative and corrective actions. This new AD requires additional reinforcement of the structure of the center fuselage by installing external stiffeners (butt straps) at frame FR53.3 on the fuselage skin between LH and RH STR13, and related investigative and other specified actions. This AD also adds airplanes to the applicability. This AD results from cracking found at the circumferential joint of FR53.3. We are issuing this AD to prevent fatigue cracking of the fuselage, which could result in reduced structural integrity of the fuselage.
Airworthiness Directives; EADS SOCATA Model TBM 700 Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as the discovery of propeller control cables with a defective crimping. Two cable ends were found uncrimped at the factory after an engine run-up test, and one cable end was also found uncrimped on the first 100-hour aircraft maintenance check. We are issuing this AD to require actions to correct the unsafe condition on these products.
Airworthiness Directives; Airbus Model A300 B4-600, B4-600R, and F4-600R Series Airplanes, and Model C4-605R Variant F Airplanes (Collectively Called A300-600 Series Airplanes); and Model A310 Airplanes; Equipped With General Electric CF6-80A3 or CF6-80C2 Engines
The FAA is adopting a new airworthiness directive (AD) for certain Airbus airplane models, as specified above. This AD requires installing electro-pneumatic locking bar devices (TRAS lock systems) in the engine nacelles, installing a dedicated and shielded electrical circuit that is segregated from the existing thrust reverser control system, and performing related investigative/corrective actions if necessary. This AD results from the manufacturer's reassessment of the thrust reverser systems in the Airbus airplane models specified above, which showed that the thrust reverser could inadvertently deploy in flight under certain conditions. We are issuing this AD to prevent inadvertent deployment of thrust reversers in flight, which could result in reduced controllability of the airplane.
Airworthiness Directives; B-N Group Ltd. BN-2, BN-2A, BN-2B, BN-2T, and BN-2T-4R Series (All Individual Models Included in Type Certificate Data Sheet (TCDS) A17EU, Revision 16, Dated December 9, 2002), and BN-2A-Mklll Trislander Series (All Individual Models Included in Type Certificate Data Sheet (TCDS) A29EU, Revision 4, Dated December 9, 2002) Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Airworthiness Directives; EADS SOCATA Model TBM 700 Airplanes
We are adopting a new airworthiness directive (AD) for the products listed above. This AD results from mandatory continuing airworthiness information (MCAI) issued by an aviation authority of another country to identify and correct an unsafe condition on an aviation product. The MCAI describes the unsafe condition as:
Office of Hazardous Materials Safety; Notice of Applications for Modification of Special Permit
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 107, subpart B) notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. This notice is abbreviated to expedite docketing and public notice. Because the sections affected, modes of transportation, and the nature of application have been shown in earlier Federal Register publications, they are not repeated here. Request of modifications of special permits (e.g. to provide for additional hazardous materials, packaging design changes, additional mode of transportation, etc.) are described in footnotes to the application number. Application numbers with the suffix ``M'' denote a modification request. These applications have been separated from the new applications for special permits to facilitate processing.
Office of Hazardous Materials Safety; Notice of Application for Special Permits
In accordance with the procedures governing the application for, and the processing of, special permits from the Department of Transportation's Hazardous Material Regulations (49 CFR part 207, subpart B), notice is hereby given that the Office of Hazardous Materials Safety has received the application described herein. Each mode of transportation for which a particular special permit is requested is indicated by a number in the ``Nature of Application'' portion of the table below as follows: 1Motor vehicle, 2Rail freight, 3Cargo vessel, 4Cargo aircraft only, 5Passenger-carrying aircraft.
Proposed Revision of Class E Airspace; Kodiak, AK
This action proposes to revise Class E airspace at Kodiak, AK. Four Standard Instrument Approach Procedures (SIAPs) are being amended for the Kodiak Airport. A Standard Instrument Departure (SID) and a Departure Procedure (DP) are also being amended. Adoption of this proposal would result in revision of existing Class E airspace upward from the surface and from 700 feet (ft.) and 1,200 ft. above the surface at Kodiak Airport, Kodiak, AK.
Proposed Revision of Class E Airspace; Port Heiden, AK
This action proposes to revise Class E airspace at Port Heiden, AK. Two new Standard Instrument Approach Procedures (SIAPs) are being developed, and two procedures are being amended for the Port Heiden Airport. A Departure Procedure (DP) is also being amended. Adoption of this proposal would result in revision of existing Class E airspace upward from 700 feet (ft.) and 1,200 ft. above the surface at Port Heiden Airport, Port Heiden, AK.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.