Department of Transportation July 25, 2006 – Federal Register Recent Federal Regulation Documents

This document revises an earlier proposed airworthiness directive (AD), applicable to certain McDonnell Douglas Model DC-8 airplanes. That proposed AD would have required a one-time inspection for cracks of the aft fuselage skin panel at the longeron 28 skin splice; repair of any cracks detected; and reporting of the findings of the inspection to the manufacturer. This new action revises the proposed AD by removing airplanes from the applicability; and adds repetitive inspections for cracks in the same area, a one-time inspection for previous repairs, and repair if necessary. This new action also would require reporting the inspection findings to the manufacturer, and would provide optional actions for extending the repetitive inspection intervals. The requirements proposed by this new action are intended to detect and correct cracks in the aft fuselage skin at the longeron 28 skin splice, which could lead to loss of structural integrity of the aft fuselage, resulting in rapid decompression of the airplane. This action is intended to address the identified unsafe condition.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket 2006-25415 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.

As authorized by Public Law 105-383 and Public Law 107-295, the Secretary of Transportation, as represented by the Maritime Administration (MARAD), is authorized to grant waivers of the U.S.- build requirement of the coastwise laws under certain circumstances. A request for such a waiver has been received by MARAD. The vessel, and a brief description of the proposed service, is listed below. The complete application is given in DOT docket 2006-25417 at https:// dms.dot.gov. Interested parties may comment on the effect this action may have on U.S. vessel builders or businesses in the U.S. that use U.S.-flag vessels. If MARAD determines, in accordance with Public Law 105-383 and MARAD's regulations at 46 CFR Part 388 (68 FR 23084; April 30, 2003), that the issuance of the waiver will have an unduly adverse effect on a U.S.-vessel builder or a business that uses U.S.-flag vessels in that business, a waiver will not be granted. Comments should refer to the docket number of this notice and the vessel name in order for MARAD to properly consider the comments. Comments should also state the commenter's interest in the waiver application, and address the waiver criteria given in Sec. 388.4 of MARAD's regulations at 46 CFR Part 388.

FMCSA announces that Isuzu Motors America, Inc. (Isuzu) has applied for an exemption for 76 of its commercial motor vehicle (CMV) drivers to enable them to test-drive Isuzu CMVs in the United States without a U.S. CDL. The Isuzu CMVs are prototypes which require testing under U.S. climatic conditions prior to being placed on the U.S. market. Each of these drivers holds a CDL issued in Japan, but lack the U.S. residency necessary to obtain a CDL in the United States. Isuzu asks that they be exempt from the Federal requirement that drivers of such CMVs hold a CDL issued by one of the States of the United States.

The FAA is adopting a new airworthiness directive (AD) for all Airbus Model A300 airplanes and Model A310 airplanes, and for certain Airbus Model A300-600 series airplanes. This AD requires an inspection of the wing and center fuel tanks to determine if certain P-clips are installed and corrective action if necessary. This AD also requires an inspection of electrical bonding points of certain equipment in the center fuel tank for the presence of a blue coat and related investigative and corrective actions if necessary. This AD also requires installation of new bonding leads and electrical bonding points on certain equipment in the wing, center, and trim fuel tanks, as necessary. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to ensure continuous electrical bonding protection of equipment in the wing, center, and trim fuel tanks and to prevent damage to wiring in the wing and center fuel tanks, due to failed P-clips used for retaining the wiring and pipes, which could result in a possible fuel ignition source in the fuel tanks.

The FAA is adopting a new airworthiness directive (AD) for certain CASA Model C-212-CC airplanes. This AD restricts the operation of the airplane to carrying either passengers or cargo (but not both) in the same compartment, unless the airplane is modified to include an approved protective liner between the passengers and the cargo. This AD results from our determination that affected airplanes, when carrying both cargo and passengers in the same compartment, cannot achieve the required level of performance. We are issuing this AD to prevent a hazardous quantity of smoke, flames, and/or fire extinguishing agent from the cargo compartment from entering a compartment occupied by passengers or crew.

This notice announces actions taken by FHWA and other Federal agencies that are final within the meaning of 23 U.S.C. 139(l)(1). The actions relate to a proposed highway project, Improvements to the U.S. Route 6/Route 10 Interchange in Providence County in the State of Rhode Island. Those actions grant licenses, permits, and approvals for the project.