Department of Transportation July 19, 2005 – Federal Register Recent Federal Regulation Documents
Results 1 - 11 of 11
Airworthiness Directives; Airbus Model A330-200, A330-300, A340-200, and A340-300 Series Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Model A330-200, A330-300, A340-200, and A340-300 series airplanes. This proposed AD would require operators to modify the hydraulic control block of the nose landing gear. This proposed AD is prompted by a report of an unexpected steering event (swerve) during the take-off roll of one affected airplane. We are proposing this AD to prevent loss of airplane steering while on the ground, which could result in the airplane going off the side of the runway.
Airworthiness Directives; Airbus Model A320-111 Airplanes, and Model A320-200 Series Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Model A320-111 airplanes, and Model A320-200 series airplanes. This proposed AD would require installing a bonding strip between each of the two water scavenge jet pumps of the center fuel tank and the rear spar in section 21. This proposed AD is prompted by the results of fuel system reviews conducted by the manufacturer. We are proposing this AD to prevent an ignition source for fuel vapor in the wing, which could result in fire or explosion in the center wing fuel tank.
Airworthiness Directives; Airbus Model A320-111 Airplanes; and Model A320-200, A321-100, and A321-200 Series Airplanes
The FAA proposes to adopt a new airworthiness directive (AD) for certain Airbus Model A320-111 airplanes; and Model A320-200, A321- 100, and A321-200 series airplanes. This proposed AD would require installing a bonding lead between the low pressure valve and the adjacent pipe assembly in each wing. This proposed AD is prompted by the results of fuel system reviews conducted by the manufacturer. We are proposing this AD to prevent an ignition source for fuel vapor in the wing, which could result in fire or explosion in the adjacent wing fuel tank.
Notice of Receipt of Petition for Decision That Nonconforming 2003-2005 Mercedes Benz SL Class (230) Passenger Cars Are Eligible for Importation
This document announces receipt by the National Highway Traffic Safety Administration (NHTSA) of a petition for a decision that 2003-2005 Mercedes Benz SL Class (230) passenger cars that were not originally manufactured to comply with all applicable Federal motor vehicle safety standards are eligible for importation into the United States because (1) they are substantially similar to vehicles that were originally manufactured for importation into and sale in the United States and that were certified by their manufacturer as complying with the safety standards, and (2) they are capable of being readily altered to conform to the standards.
Performance of Advanced Crash Avoidance Systems; Request for Information
The National Highway Traffic Safety Administration (NHTSA) is seeking information from all sources for its Advanced Crash Avoidance Technologies Program (ACAT). The ACAT program seeks to determine the safety impact of new and emerging technologies that are intended to help drivers avoid crashes, reduce the severity, and prevent injuries.
Nondiscrimination on the Basis of Disability
This document responds to a Congressional mandate for the U.S. Department of Transportation to provide a technical assistance manual to air carriers and individuals with disabilities concerning their rights and responsibilities under the Air Carrier Access Act and DOT regulations.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
