Occupational Safety and Health Administration June 2007 – Federal Register Recent Federal Regulation Documents
Results 1 - 8 of 8
Construction Records for Rigging Equipment; Extension of the Office of Management and Budget's (OMB) Approval of Information Collection (Paperwork) Requirements
OSHA solicits public comment concerning its proposal to extend OMB approval of the information collection requirements contained in paragraphs (b)(1), (b)(6)(i), (b)(6)(ii), (c)(15)(ii), (e)(1)(i), (ii), and (iii) and (f)(2) of the Rigging Equipment for Construction Standard (29 CFR 1926.251). These paragraphs require affixing identification tags or markings on rigging equipment, developing and maintaining inspection records, and retaining proof-testing certificates.
The Hydrostatic Testing Provision of the Standard on Portable Fire Extinguishers; Extension of the Office of Management and Budget's (OMB) Approval of Information Collection (Paperwork) Requirements
OSHA solicits public comment concerning its proposal to extend OMB approval of the information collection requirements specified in the Hydrostatic Testing Provision of the Standard on Portable Fire Extinguishers (29 CFR 1910.157(f)(16)). The hydrostatic testing provision requires employers to certify that portable fire extinguishers have been hydrostatically tested as prescribed by the Standard by preparing a certification record upon completion of the test. The record must be maintained on file and made available to OSHA compliance staff.
Grantee Quarterly Progress Report; Extension of the Office of Management and Budget's (OMB) Approval of Information Collection (Paperwork) Requirements
OSHA solicits public comments concerning its proposal to extend OMB approval of the information collection requirements contained in the Grantee Quarterly Progress Report required by Section 21 of the Occupational Safety and Health Act of 1970 (the ``OSH Act'') (29 U.S.C. 670).
Interpretation of OSHA's Standard for Process Safety Management of Highly Hazardous Chemicals
This Notice constitutes the Occupational Safety and Health Administration's official interpretation and explanation of the phrase ``on site in one location'' in the ``Application'' section of OSHA's Process Safety Management of Highly Hazardous Chemicals standard. (``PSM'').
Power Presses
Mechanical power press safety is regulated under OSHA's mechanical power presses standard. OSHA adopted the standard in 1971, basing it upon the 1971 edition of American National Standards Institute (ANSI) B11.1, the industry consensus standard for mechanical power presses. This ANSI standard has been updated a number of times since OSHA adopted the 1971 version. The most recent edition was issued in 2001. Hydraulic and pneumatic power presses are not covered by OSHA's current standard. The original standard also did not address the use of presence-sensing-device initiation (PSDI) systems. When a press is equipped with PSDI, the press cycle will not initiate until the PSDI system senses that the danger zone is clear. OSHA updated the mechanical power presses standard on March 14, 1988, (53 FR 8353), to permit the use of PSDI systems. However, it requires an OSHA-approved third party to validate the PSDI system at installation and annually thereafter. Since the adoption of this provision, no third party has sought OSHA's approval. Consequently, PSDI systems are not being used with mechanical power presses. OSHA is seeking comments on whether and how the mechanical power presses standard should be amended, including whether the requirements pertaining to the use of PSDI systems should be revised and whether the scope of the standard should be expanded to cover other types of presses.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
