June 11, 2021 – Federal Register Recent Federal Regulation Documents

This action amends the Class E airspace area extending upward from 1,200 feet above the surface over the State of Michigan and removes overlapping and redundant enroute domestic airspace areas within these boundaries. This action corrects, simplifies, and closes gaps in the Class E airspace extending upward from 1,200 feet above the surface over the State of Michigan; provides transitional airspace to support instrument flight rule (IFR) operations to and from the terminal and enroute environments within the state; and improves air traffic control services over the state.

The FAA is superseding Airworthiness Directive (AD) 2019-03- 10, which applied to all Airbus SAS Model A300 series airplanes; and Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes). AD 2019-03-10 required repetitive detailed visual inspections of the main landing gear (MLG) leg components and replacement of the MLG leg if cracked components are found. This AD continues to require the actions required by AD 2019-03-10. For certain airplanes, this AD also requires modification of the MLG hinge arm by installing improved MLG hinge arm/barrel pins; an out-of-roundness check of removed pins; repetitive inspections of any affected pins and the associated connecting rod bushes, and replacement of the MLG leg if cracked components are found; and installation of an improved spacer; as specified in a European Union Aviation Safety Agency (EASA) AD, which is incorporated by reference. This AD was prompted by reports of cracks in MLG leg components and a determination that additional actions (including inspections, modifications, and checks) are needed to address the unsafe condition. The FAA is issuing this AD to address the unsafe condition on these products.

The U.S. Department of Energy (``DOE'') is undertaking an early assessment review to determine whether amendments are warranted for the test procedure for commercial refrigerators, refrigerator- freezers, and freezers (``CRE''). DOE has identified certain issues associated with the currently applicable test procedure on which DOE is interested in receiving comment. The issues identified in this document concern scope and definitions, industry test standards, test conditions for specific CRE categories, test procedure clarifications and modifications, alternative refrigerants, certification of volumes, and test procedure waivers. DOE welcomes written comments from the public on any subject within the scope of this document, including topics not raised in this request for information (``RFI'').

GAO is now accepting comments on estimated potential lump sum catch-up payments to certain 9/11 victims, 9/11 spouses, and 9/11 dependents who have submitted eligible claims for payment from the United States Victims of State Sponsored Terrorism Fund. GAO is conducting a review and publishing this notice pursuant to the requirements of the Sudan Claims Resolution Act. Comments should be sent to the email address below.

This document corrects the final rule published by the Occupational Safety and Health Review Commission in the Federal Register on May 17, 2021. That rule revised the Occupational Safety and Health Review Commission's rules implementing the Equal Access to Justice Act.

The Board is proposing amendments to Regulation J to govern funds transfers through the Federal Reserve Banks' (Reserve Banks) new FedNow\SM\ Service by establishing a new subpart C. The Board is also proposing changes and clarifications to subpart B, governing the Fedwire Funds Service, to reflect the fact that the Reserve Banks will be operating a second funds transfer service in addition to the Fedwire Funds Service, as well as proposing technical corrections to subpart A, governing the check service.

On September 19, 2019, the Securities and Exchange Commission (the ``Commission'') adopted recordkeeping, reporting, and notification requirements applicable to security-based swap dealers and major security-based swap participants, securities count requirements applicable to certain security-based swap dealers, and additional recordkeeping requirements applicable to broker-dealers to account for their security-based swap and swap activities. Release 34-87005 (Sept. 19, 2019) was published in the Federal Register on Dec. 16, 2019 ( ). This document corrects certain technical inaccuracies in that release.

The Department of the Treasury, as part of its continuing effort to reduce paperwork and respondent burden, invites the general public and other Federal agencies to take this opportunity to comment on proposed and/or continuing information collections, as required by the Paperwork Reduction Act of 1995. Currently the Bureau of the Fiscal Service within the Department of the Treasury is soliciting comments concerning the Special Form of Assignment for U.S. Registered Securities.

The Department of Justice, Office of Justice Programs, is amending the Formula Grants Program implementing regulation authorized under title II, part B, of the Juvenile Justice and Delinquency Prevention Act (JJDP Act) and promulgated in 1996, to remove sections and/or provisions that were rendered obsolete by amendments made to the JJDP Act in 2002 or in 2018; are redundant; or are ultra vires. Additional technical corrections reflect an editorial reclassification of the United States Code, implemented on September 1, 2017, that reorganized certain existing provisions of the United States Code into a new title, and citations are updated to reflect sections of the Act that were re-numbered by the 2002 amendments. Finally, the definitions in the regulation have been rearranged to be listed in alphabetical order.