November 17, 2015 – Federal Register Recent Federal Regulation Documents

Safety Zone; Unexploded Ordnance Detonation; Passage Key, FL
Document Number: 2015-29347
Type: Rule
Date: 2015-11-17
Agency: Coast Guard, Department of Homeland Security
The Coast Guard is establishing a temporary safety zone within a 2000-ft radius of an ordnance detonation area. The safety zone is needed to protect personnel, vessels, and the marine environment from potential hazards created by the unexploded ordnance detonation. Entry of vessels or persons into this zone is prohibited unless specifically authorized by the Captain of the Port St. Petersburg.
Instituting Smoke-Free Public Housing
Document Number: 2015-29346
Type: Proposed Rule
Date: 2015-11-17
Agency: Department of Housing and Urban Development
This proposed rule would require each public housing agency (PHA) administering public housing to implement a smoke-free policy. Specifically, this rule proposes that no later than 18 months from the effective date of the final rule, each PHA must implement a policy prohibiting lit tobacco products in all living units, indoor common areas in public housing, and in PHA administrative office buildings (in brief, a smoke-free policy for all public housing indoor areas). The smoke-free policy must also extend to all outdoor areas up to 25 feet from the housing and administrative office buildings. HUD proposes implementation of smoke-free public housing to improve indoor air quality in the housing, benefit the health of public housing residents and PHA staff, reduce the risk of catastrophic fires, and lower overall maintenance costs.
Reserve Requirements of Depository Institutions
Document Number: 2015-29336
Type: Rule
Date: 2015-11-17
Agency: Federal Reserve System, Agencies and Commissions
The Board is amending Regulation D, Reserve Requirements of Depository Institutions, to reflect the annual indexing of the reserve requirement exemption amount and the low reserve tranche for 2016. The Regulation D amendments set the amount of total reservable liabilities of each depository institution that is subject to a zero percent reserve requirement in 2016 at $15.2 million (from $14.5 million in 2015). This amount is known as the reserve requirement exemption amount. The Regulation D amendments also set the amount of net transaction accounts at each depository institution (over the reserve requirement exemption amount) that is subject to a three percent reserve requirement in 2016 at $110.2 million (from $103.6 million in 2015). This amount is known as the low reserve tranche. The adjustments to both of these amounts are derived using statutory formulas specified in the Federal Reserve Act. The Board is also announcing changes in two other amounts, the nonexempt deposit cutoff level and the reduced reporting limit, that are used to determine the frequency at which depository institutions must submit deposit reports.
Administration of Multiemployer Plan Participant Vote on an Approved Suspension of Benefits Under MPRA; Hearing
Document Number: 2015-29289
Type: Proposed Rule
Date: 2015-11-17
Agency: Internal Revenue Service, Department of Treasury, Department of the Treasury
This document provides notice of public hearing on proposed regulations relating to the administration of a multiemployer plan participant vote on an approved suspension of benefits under the Multiemployer Pension Reform Act of 2014 (MPRA) that were issued in the Proposed Rules section of the Federal Register on September 2, 2015.
Microbiology Devices; Classification of In Vitro Diagnostic Devices for Bacillus Species Detection
Document Number: 2015-29275
Type: Proposed Rule
Date: 2015-11-17
Agency: Food and Drug Administration, Department of Health and Human Services
The Food and Drug Administration (FDA) is re-proposing to classify in vitro diagnostic devices for Bacillus species (spp.) detection into class II (special controls) after considering, among other information, the recommendations of the Microbiology Devices Advisory Panel (the Panel). FDA is re-proposing to establish special controls in a draft special controls guideline that the Agency believes are necessary to provide a reasonable assurance of the safety and effectiveness of the devices. In addition, FDA is re-proposing to restrict use and distribution of the devices. FDA is publishing in this proposed rule the recommendations of the Panel regarding the classification of the devices.
Collection of Connected Entity Data from Regional Transmission Organizations and Independent System Operators
Document Number: 2015-29268
Type: Proposed Rule
Date: 2015-11-17
Agency: Department of Energy, Federal Energy Regulatory Commission
In this order, the Federal Energy Regulatory Commission (Commission) grants a motion for a technical conference and request to postpone comment deadline that was filed in response to the Notice of Proposed Rulemaking for the Collection of Connected Entity Data from Regional Transmission Organizations and Independent System Operators (NOPR) that Commission issued on September 17, 2015.\1\ The Commission directs staff to convene a technical conference on December 8, 2015 and postpones the due date for comments on the NOPR until January 22, 2016, 45 days after the technical conference.
Expanding the Economic and Innovation Opportunities of Spectrum Through Incentive Auctions
Document Number: 2015-29239
Type: Rule
Date: 2015-11-17
Agency: Federal Communications Commission, Agencies and Commissions
This document resolves the remaining technical issues affecting the operation of new 600 MHz wireless licensees and broadcast television stations in areas where they operate on the same or adjacent channels in geographic proximity. Specifically, the Commission adopted the methodology and the regulatory framework for the protection of both wireless services and broadcasting in the post-auction environment that it proposed in October 2014. The Commission affirms its decision regarding the methodology to be used during the incentive auction to predict inter-service interference between broadcasting and wireless services. The Commission also affirmed its decision declining to adopt a cap on the aggregate amount of new interference a broadcast television station may receive from other television stations in the repacking process.
Freedom of Information Act Procedures
Document Number: 2015-29183
Type: Rule
Date: 2015-11-17
Agency: Department of Homeland Security, U.S. Customs and Border Protection
This final rule amends the U.S. Customs and Border Protection (``CBP'') Freedom of Information Act (``FOIA'') regulations. Due to the transfer of CBP from the Department of the Treasury to the Department of Homeland Security (``DHS''), and the subsequent promulgation of DHS FOIA regulations which provide that the DHS FOIA regulations generally apply to all DHS components, most of the CBP FOIA regulations have been functionally superseded. This document sets forth that, with the exception of a regulation pertaining to the treatment of confidential commercial information, CBP will apply the DHS FOIA and Privacy Act regulations for purposes of administering the FOIA. This final rule removes outdated regulations, aligns CBP's regulatory procedures for processing FOIA requests with those of DHS, thereby creating a consistent standard among the DHS components, and brings CBP within compliance of the FOIA guidelines developed by OMB.
Approval and Promulgation of Implementation Plans; Washington: Additional Regulations for the Benton Clean Air Agency Jurisdiction
Document Number: 2015-29180
Type: Rule
Date: 2015-11-17
Agency: Environmental Protection Agency
The Environmental Protection Agency (EPA) is approving revisions to the Washington State Implementation Plan (SIP) that were submitted by the Department of Ecology (Ecology) in coordination with Benton Clean Air Agency (BCAA) on August 25, 2015. In the fall of 2014 and spring of 2015, the EPA approved numerous revisions to Ecology's general air quality regulations. However, our approval of the updated Ecology regulations applied only to geographic areas where Ecology, and not a local air authority, has jurisdiction, and statewide to source categories over which Ecology has sole jurisdiction. This final approval allows BCAA to rely primarily on Ecology's general air quality regulations for sources within BCAA's jurisdiction, including implementation of the minor new source review and nonattainment new source review permitting programs. This final action also approves of a small set of BCAA regulatory provisions that replace or supplement parts of Ecology's general air quality regulations.
Rules, Regulations, Statements of General Policy or Interpretation and Exemptions Under the Fair Packaging and Labeling Act
Document Number: 2015-28918
Type: Rule
Date: 2015-11-17
Agency: Federal Trade Commission, Agencies and Commissions
The Commission amends the rules and regulations promulgated under the Fair Packaging and Labeling Act (``Rules'') to: Modernize the place-of-business listing requirement; incorporate a more comprehensive metric chart; address the use of exponents with customary inch/pound measurements; delete outdated prohibitions on retail price sales representations; and acknowledge the role of the weights-and-measures laws of individual states.
Airworthiness Directives; General Electric Company Turbofan Engines
Document Number: 2015-28898
Type: Proposed Rule
Date: 2015-11-17
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for all General Electric Company (GE) CF6-80E1 turbofan engines with rotating compressor discharge pressure (CDP) seal, part number (P/N) 1669M73P02, installed. This proposed AD was prompted by reports from the manufacturer of cracks in the teeth of two rotating CDP seals found during engine shop visits. This proposed AD would require stripping of the coating, inspecting, and recoating the teeth of the affected rotating CDP seals. We are proposing this AD to prevent cracking of the CDP seal teeth, which can lead to uncontained part release, damage to the engine, and damage to the airplane.
Airworthiness Directives; Airbus Airplanes
Document Number: 2015-28892
Type: Proposed Rule
Date: 2015-11-17
Agency: Federal Aviation Administration, Department of Transportation
We propose to supersede Airworthiness Directive (AD) 99-16-01, for certain Airbus Model A300 B4-600, B4-600R, and F4-600R series airplanes, and Model A300 C4-605R Variant F airplanes (collectively called Model A300-600 series airplanes). AD 99-16-01 currently requires repetitive inspections of certain bolt holes where parts of the main landing gear (MLG) are attached to the wing rear spar, and repair if necessary. Since we issued AD-99-16-01, we have determined that the risk of cracking in the rear spar is higher than initially determined. This proposed AD would add airplanes to the applicability, reduce the compliance times and repetitive intervals for the inspections, and change the inspection procedures. We are proposing this AD to detect and correct cracking of the rear spar of the wing, which could result in reduced structural integrity of the airplane.
Airworthiness Directives; Bombardier, Inc. Airplanes
Document Number: 2015-28885
Type: Proposed Rule
Date: 2015-11-17
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model CL-600-2B19 (Regional Jet Series 100 & 440) airplanes. This proposed AD was prompted by the discovery of a number of incorrectly calibrated angle of attack (AOA) transducers installed in the stall protection system. This proposed AD would require replacement of incorrectly calibrated AOA transducers. We are proposing this AD to detect and replace incorrectly calibrated AOA transducers; incorrect calibration of the transducers could result in late activation of the stick pusher.
Airworthiness Directives; The Boeing Company Airplanes
Document Number: 2015-28882
Type: Proposed Rule
Date: 2015-11-17
Agency: Federal Aviation Administration, Department of Transportation
We propose to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 787-8 airplanes. This proposed AD was prompted by a report that certain center and outboard stowage bin modules were incorrectly installed. This proposed AD would require an inspection of the center and outboard stowage bin modules for missing parts, quick release pins that are not fully engaged, and parts that are installed in incorrect locations; and corrective actions if necessary. We are proposing this AD to detect and correct incorrectly installed center and outboard stowage bin modules that might not remain intact during an emergency landing, resulting in injuries to occupants and interference with airplane evacuation.
Airworthiness Directives; Bombardier, Inc. Airplanes
Document Number: 2015-28822
Type: Rule
Date: 2015-11-17
Agency: Federal Aviation Administration, Department of Transportation
We are adopting a new airworthiness directive (AD) for certain Bombardier, Inc. Model BD-100-1A10 (Challenger 300) airplanes. This AD was prompted by multiple reports of chafing found on an electrical wiring harness in the aft equipment bay, caused by contact between the wiring harness and a neighboring hydraulic line. This AD requires an inspection, repair if necessary, and modification of the wiring harness installation to ensure that the wiring harness routing is correct and a minimum clearance between the wire and the hydraulic line is maintained. We are issuing this AD to detect and correct chafing on an electrical wiring harness, which could cause an electrical short circuit or lead to a malfunction of the flight control system, the engine indication system, or the hydraulic power control system; and adversely affect the continued safe operation and landing of the airplane.
Promoting Spectrum Access for Wireless Microphone Operations
Document Number: 2015-28778
Type: Rule
Date: 2015-11-17
Agency: Federal Communications Commission, Agencies and Commissions
In this document, the Commission takes several steps to accommodate the long-term needs of wireless microphone users. Wireless microphones play an important role in enabling broadcasters and other video programming networks to serve consumers, including as they cover breaking news and live sports events. They enhance event productions in a variety of settingsincluding theaters and music venues, film studios, conventions, corporate events, houses of worship, and internet webcasts. They also help create high quality content that consumers demand and value. In particular, the Commission provides additional opportunities for wireless microphone operations in the TV bands following the upcoming incentive auction, and provides new opportunities for wireless microphone operations to access spectrum in other frequency bands where they can share use of the bands without harming existing users.
Implementation of Uniform Administrative Requirements, Cost Principles, and Audit Requirements for Federal Awards
Document Number: 2015-28733
Type: Rule
Date: 2015-11-17
Agency: Corporation for National and Community Service, Agencies and Commissions
The Corporation for National and Community Service (CNCS) published an interim final rule adopting and implementing the Uniform Administrative Requirements, Cost Principles, and Audit Requirements for Federal Awards (Uniform Guidance) on December 19, 2014. CNCS publishes this final rule to adopt and implement the interim final rule without change.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.