January 23, 2015 – Federal Register Recent Federal Regulation Documents

This notice announces actions taken by FHWA and other Federal agencies that are final within the meaning of 23 U.S.C. 139(1)(1). The actions relate to the Portageville Bridge Project. Those actions grant approvals for the project.

We propose to adopt a new airworthiness directive (AD) for all Airbus Model A330-200, A330-200 Freighter, and A330-300 series airplanes; and Airbus Model A340-200, A340-300, A340-500, and A340-600 series airplanes. This proposed AD was prompted by a report that, during a production flight test, the ram air turbine (RAT) did not pressurize the green hydraulic system. For certain airplanes, this proposed AD would require identification of the part number, serial number, and standard of the RAT pump, RAT module, RAT actuator, and RAT lower gearbox assembly; replacement of the balance weight screw, modification of the actuator coil spring, modification of the actuator, an inspection of the anti-stall valve for correct installation in the RAT pump housing; and corrective actions if necessary. For certain other airplanes, this proposed AD would require re-identification or replacement of the RAT module. We are proposing this AD to prevent loss of the impeller function and RAT pump pressurization capability, which, if preceded by a total engine flame-out, could result in the loss of control of the airplane.

We propose to adopt a new airworthiness directive (AD) for all Fokker Services B.V. Model F.28 Mark 0070 and 0100 airplanes. This proposed AD was prompted by reports that cracks can occur in a frame of the tail section on certain airplanes. This proposed AD would require a one-time detailed inspection of the oblique frame 67-2 for any cracking, and repair if necessary. We are proposing this AD to detect and correct such cracking, which could lead to failure of the oblique frame 67-2, and consequent loss of the structural integrity of the tail section.

We propose to adopt a new airworthiness directive (AD) for certain Bombardier, Inc. Model DHC-8-400 series airplanes. This proposed AD was prompted by an in-service report of an uncommanded and unannunciated nose wheel steering during airplane pushback from the gate. This proposed AD would require installing new cable assemblies with a pull-down resistor. We are proposing this AD to prevent an uncommanded nose wheel steering during takeoff or landing in the event of an open circuit in the steering system, and possible consequent runway excursion.

We propose to supersede Airworthiness Directive (AD) 2004-13- 02, which applies to certain The Boeing Company Model 747-100, -200B, and -200F series airplanes. AD 2004-13-02 currently requires initial and repetitive inspections to find discrepancies in the upper and lower skins of the fuselage lap joints, and repair if necessary. Since we issued AD 2004-13-02, an evaluation by the design approval holder (DAH) indicates that the longitudinal lap joints are subject to widespread fatigue damage (WFD), and that a structural modification at the lap joint, and post-modification repetitive inspections of the skin, existing internal doubler, or splice strap for cracks, and corrective actions if necessary, are required to reach the limit of validity (LOV). This proposed AD would add post-repair inspections for cracking and corrosion, and repair if necessary; structural modification at the lap joints; and post-modification inspections for cracking and corrosion, and repair if necessary. We are proposing this AD to detect and correct fatigue cracking in the upper and lower skins of the fuselage lap joints, which could result in sudden fracture and failure of a lap joint and rapid in-flight decompression of the airplane fuselage.

We propose to adopt a new airworthiness directive (AD) for certain Airbus Model A319, A320, and A321 series airplanes. This proposed AD was prompted by reports that on airplanes equipped with sharklets, discretes (used to activate the load alleviation function) are connected on various flight computers using the same ground point. In these cases, the ground point segregation is no longer effective and a single failure could lead to loss of sharklet identification by flight computers causing a return to the wing tip fence (no sharklet configuration) performance. This proposed AD would require modification of the sharklet ground connection. We are proposing this AD to prevent loss of sharklet identification by the flight computers and subsequent reduced control of the airplane.

We propose to adopt a new airworthiness directive (AD) for certain Airbus Model A318, A319, A320, and A321 series airplanes. This proposed AD was prompted by a report that, during the assembly process, several gaps between the two parts of the girt bar fittings for the aft passenger doors were found to exceed tolerances. This proposed AD would require an inspection of the gap between the two parts of the girt bar fittings on left-hand (LH) and right-hand (RH) aft passenger doors, and corrective actions if necessary. We are proposing this AD to detect and correct incorrect gaps between the girt bar fittings. Detachment of a girt bar could lead to the separation of the slide or slide-raft from the fuselage, making the emergency exit inoperative, which could impede an emergency evacuation.

This Notice identifies unutilized, underutilized, excess, and surplus Federal property reviewed by HUD for suitability for possible use to assist the homeless.

The Agency for Healthcare Research and Quality (AHRQ) is seeking scientific information submissions from the public. Scientific information is being solicited to inform our review of ``Noninvasive Testing for Coronary Artery Disease'', which is currently being conducted by the AHRQ's Evidence-based Practice Centers (EPC) Programs. Access to published and unpublished pertinent scientific information will improve the quality of this review. AHRQ is conducting this systematic review pursuant to Section 902(a) of the Public Health Service Act, 42 U.S.C. 299a(a).

PHMSA proposes to make miscellaneous amendments to the Hazardous Materials Regulations to update and clarify certain regulatory requirements. These proposed amendments are designed to promote safer transportation practices, address petitions for rulemaking, respond to National Transportation Safety Board (NTSB) Safety Recommendations, facilitate international commerce, make editorial corrections, and simplify the regulations. The proposed provisions in this rulemaking include, but are not limited to, removing the packing group (PG) II designation for certain organic peroxides, self-reactive substances and explosives, incorporating requirements for trailers of manifolded acetylene cylinders, and providing requirements to allow for shipments of damaged wet electric batteries. In addition, this rulemaking proposes to revise the requirements for the packaging of nitric acid, testing of pressure relief devices on cargo tanks, and shipments of black or smokeless powder for small arms.