June 7, 2006 – Federal Register Recent Federal Regulation Documents
Results 151 - 158 of 158
Airworthiness Directives; Boeing Model 747-100B, 747-200B, 747-200F, 747-300, 747-400, 747-400F, and 747SP Series Airplanes
The FAA is adopting a new airworthiness directive (AD) for certain 747-100B, 747-200B, 747-200F, 747-300, 747-400, 747-400F, and 747SP series airplanes. This AD requires doing inspections of the midpivot bolt and midpivot bolt access door of the spring beam of the inboard side of the outboard struts for discrepancies, installing a placard on the midpivot bolt access door, and applicable corrective actions if necessary. This AD results from reports indicating that the midpivot bolt and midpivot bolt access door of the spring beam of the inboard side of the outboard struts were installed in the incorrect position. We are issuing this AD to ensure that the subject midpivot bolts and midpivot bolt access doors are installed in the correct position. If not installed in the correct position, a midpivot bolt could be overloaded and crack or fracture, which could result in the loss of the spring load path and consequent separation of the associated outboard strut and engine from the airplane.
Airworthiness Directives; Airbus Model A300 B4 Series Airplanes; Model A300 B4-600 Series Airplanes; Model A300 C4-605R Variant F Airplanes; Model A310-200 Series Airplanes; and Model A310-300 Series Airplanes
The FAA is superseding an existing airworthiness directive (AD), which applies to certain Airbus Model A300 B4-600 and A300 C4-600 series airplanes. That AD currently requires a one-time inspection to detect damage of the pump diffuser guide slots (bayonet) of the center tank fuel pumps, the pump diffuser housings, and the pump canisters; repetitive inspections to detect damage of the fuel pumps and the fuel pump canisters; and corrective action, if necessary. This new AD adds, for new airplanes, repetitive inspections of the pump bodies for cracking, damage, and missing and broken fasteners; repetitive inspections of the fuel pump canisters for a cracked flange web; and corrective actions if necessary. For all airplanes, this new AD also adds replacement of the fuel pump canisters with new reinforced fuel pump canisters, which ends the repetitive inspections. This AD results from fuel system reviews conducted by the manufacturer. We are issuing this AD to detect and correct damage of the center tank fuel pumps and fuel pump canisters, which could result in separation of a pump from its electrical motor housing, loss of flame trap capability, and a possible fuel ignition source in the center fuel tank.
Airworthiness Directives; Airbus Model A321-100 Series Airplanes
The FAA is revising an existing airworthiness directive (AD) that applies to certain Airbus Model A321-111, -112, and -131 airplanes. That AD currently requires repetitive inspections to detect fatigue cracking in the area surrounding certain attachment holes of the forward pintle fittings of the main landing gear (MLG) and the actuating cylinder anchorage fittings on the inner rear spar; and repair, if necessary. That AD also provides for optional terminating action for the repetitive inspections, adds inspections of three additional mounting holes, and revises the thresholds for the currently required inspections. We issued that AD to detect and correct fatigue cracking on the inner rear spar of the wings, which could result in reduced structural integrity of the airplane. This new AD retains the requirements and revises the applicability of that AD. This AD results from the discovery of a typographical error in the applicability of that AD, which could cause the unsafe condition on an affected airplane to remain uncorrected. We are issuing this AD to detect and correct fatigue cracking on the inner rear spar of the wings, which could result in reduced structural integrity of the airplane.
Airworthiness Directives; Boeing Model 737-300, -400, -500, -700, and -800 Series Airplanes; Model 747-400 and -400F Series Airplanes; Model 757-200 Series Airplanes; Model 767-300 Series Airplanes; and Model 777-300 Series Airplanes Equipped With Certain Driessen or Showa Galleys or Driessen Closets
The FAA is adopting a new airworthiness directive (AD) for certain Boeing transport category airplanes. This AD requires inspecting to determine if certain galleys and closets are installed, and replacing the spiral wire wrapping of the electrical cables of the galleys and closets with new spiral wire wrapping if necessary. This AD results from testing and reports from the manufacturer indicating unacceptable flammability properties of wire wrapping installed in certain galleys and closets. We are issuing this AD to prevent fire propagation or smoke in the cabin area due to electrical arcing or sparking and ignition of the spiral wire wrapping.
Fisheries of the Exclusive Economic Zone Off Alaska; Allocating Gulf of Alaska Fishery Resources
NMFS issues a proposed rule to Amendment 68 to the Fishery Management Plan for Groundfish of the Gulf of Alaska (FMP). This action would implement statutory provisions for the Central Gulf of Alaska Rockfish Pilot Program (hereinafter referred to as the Program). This proposed action is necessary to increase resource conservation and improve economic efficiency for harvesters and processors who participate in the fishery. This action is intended to promote the goals and objectives of the Magnuson-Stevens Fishery Conservation and Management Act (Magnuson-Stevens Act), the FMP, and other applicable law.
Market-Based Rates for Wholesale Sales of Electric Energy, Capacity and Ancillary Services by Public Utilities
The Federal Energy Regulatory Commission (Commission) is proposing to amend its regulations to revise Subpart H to Part 35 of Title 18 of the Code of Federal Regulations governing market-based rates for public utilities pursuant to the Federal Power Act (FPA). The Commission is proposing to codify and, in certain respects, revise its current standards for market-based rates for sales of electric energy, capacity, and ancillary services. The Commission is proposing to retain several of the core elements of its current standards for granting market-based rates. However, we propose certain revisions to these standards and seek comment on other issues. The Commission also proposes to streamline certain aspects of its filing requirements to reduce the administrative burdens on applicants, customers and the Commission.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
