Cooper Tire & Rubber Company, Receipt of Petition for Decision of Inconsequential Noncompliance, 43934 [05-14975]

Download as PDF 43934 Federal Register / Vol. 70, No. 145 / Friday, July 29, 2005 / Notices Intended Use: ‘‘Vessel will be used for hire for guided bear hunting and guided charters in Alaska.’’ Geographic Region: Inshore and near shore waters of Alaska. Dated: July 18, 2005. By order of the Maritime Administrator. Joel C. Richard, Secretary, Maritime Administration. [FR Doc. 05–15071 Filed 7–28–05; 8:45 am] BILLING CODE 4910–81–P DEPARTMENT OF TRANSPORTATION National Highway Traffic Safety Administration [Docket No. NHTSA–2005–21930; Notice 1] Cooper Tire & Rubber Company, Receipt of Petition for Decision of Inconsequential Noncompliance Cooper Tire & Rubber Company (Cooper) has determined that certain tires it produced in 2005 do not comply with S4.3(e) of 49 CFR 571.109, Federal Motor Vehicle Safety Standard (FMVSS) No. 109, ‘‘New pneumatic tires.’’ Cooper has filed an appropriate report pursuant to 49 CFR part 573, ‘‘Defect and Noncompliance Reports.’’ Pursuant to 49 U.S.C. 30118(d) and 30120(h), Cooper has petitioned for an exemption from the notification and remedy requirements of 49 U.S.C. chapter 301 on the basis that this noncompliance is inconsequential to motor vehicle safety. This notice of receipt of Cooper’s petition is published under 49 U.S.C. 30118 and 30120 and does not represent any agency decision or other exercise of judgment concerning the merits of the petition. Cooper produced approximately 3,070 Cooper brand tires during the period from January 30, 2005 through May 21, 2005 that do not comply with FMVSS No. 109, S4.3(e). S4.3(e) of FMVSS No. 109 requires that ‘‘each tire shall have permanently molded into or onto both sidewalls * * * (e) Actual number of plies in the sidewall, and the actual number of plies in the tread area if different.’’ The noncompliant tires were marked ‘‘tread 1 ply nylon + 2 ply steel + 1 ply polyester; sidewall 2 ply polyester.’’ The correct marking should read ‘‘tread 1 ply nylon, 2 ply steel + 2 ply polyester; sidewall 2 ply polyester.’’ Cooper believes that the noncompliance is inconsequential to motor vehicle safety and that no corrective action is warranted. Cooper states that ‘‘the incorrect number of tread plies on each tire does not present a safety-related defect. The subject tires, VerDate jul<14>2003 17:05 Jul 28, 2005 Jkt 205001 in fact, have 2 polyester tread plies.’’ Cooper states that the tires comply with all other requirements of FMVSS No. 119. Interested persons are invited to submit written data, views, and arguments on the petition described above. Comments must refer to the docket and notice number cited at the beginning of this notice and be submitted by any of the following methods. Mail: Docket Management Facility, U.S. Department of Transportation, Nassif Building, Room PL–401, 400 Seventh Street, SW., Washington, DC, 20590–0001. Hand Delivery: Room PL–401 on the plaza level of the Nassif Building, 400 Seventh Street, SW., Washington, DC. It is requested, but not required, that two copies of the comments be provided. The Docket Section is open on weekdays from 10 a.m. to 5 p.m. except Federal holidays. Comments may be submitted electronically by logging onto the Docket Management System Web site at https://dms.dot.gov. Click on ‘‘Help’’ to obtain instructions for filing the document electronically. Comments may be faxed to 1–202–493–2251, or may be submitted to the Federal eRulemaking Portal: go to https:// www.regulations.gov. Follow the online instructions for submitting comments. The petition, supporting materials, and all comments received before the close of business on the closing date indicated below will be filed and will be considered. All comments and supporting materials received after the closing date will also be filed and will be considered to the extent possible. When the petition is granted or denied, notice of the decision will be published in the Federal Register pursuant to the authority indicated below. Comment closing date: August 29, 2005. Authority: 49 U.S.C. 30118, 30120: delegations of authority at CFR 1.50 and 501.8. Issued on: July 22, 2005. Ronald L. Medford, Senior Associate Administrator for Vehicle Safety. [FR Doc. 05–14975 Filed 7–28–05; 8:45 am] BILLING CODE 4910–59–P PO 00000 Frm 00098 Fmt 4703 Sfmt 4703 DEPARTMENT OF TRANSPORTATION National Highway Traffic Safety Administration [Docket No. NHTSA–2005–21926; Notice 1] Cooper Tire & Rubber Company, Receipt of Petition for Decision of Inconsequential Noncompliance Cooper Tire & Rubber Company (Cooper) has determined that the markings on certain tires that it produced in 2004 and 2005 do not comply with S4.3(a) of 49 CFR 571.109, Federal Motor Vehicle Safety Standard (FMVSS) No. 109, ‘‘New pneumatic tires.’’ Cooper has filed an appropriate report pursuant to 49 CFR part 573, ‘‘Defect and Noncompliance Reports.’’ Pursuant to 49 U.S.C. 30118(d) and 30120(h), Cooper has petitioned for an exemption from the notification and remedy requirements of 49 U.S.C. chapter 301 on the basis that this noncompliance is inconsequential to motor vehicle safety. This notice of receipt of Cooper’s petition is published under 49 U.S.C. 30118 and 30120 and does not represent any agency decision or other exercise of judgment concerning the merits of the petition. Affected are a total of approximately 2,606 Cooper Discoverer AST II tires in the 265/70R16 size, produced between October 10, 2004 and April 16, 2005. S4.3, Labeling requirements, requires compliance with 49 CFR part 574.5, ‘‘Tire Identification and Record Keeping, Tire Identification Requirements.’’ The size designation required by part 574.5 was incorrectly marked on the subject tires, which were molded with the letters ‘‘TY’’ as the second grouping of symbols in the tire identification number. The correct stamping should have been ‘‘C2.’’ Cooper believes that the noncompliance is inconsequential to motor vehicle safety and that no corrective action is warranted. Cooper states that the purpose of the tire identification number marking requirements is to facilitate the ability of the tire manufacturer to identify the tires in the event of a recall. Cooper asserts that the incorrect size designation in this case does not affect the ability to identify defective or nonconforming tires. Cooper points out that the tire size is correctly stamped on the sidewalls of the subject tires, and states that the tires comply with all other requirements of FMVSS No. 109 and 49 CFR 574.5. Interested persons are invited to submit written data, views, and arguments on the petition described E:\FR\FM\29JYN1.SGM 29JYN1

Agencies

[Federal Register Volume 70, Number 145 (Friday, July 29, 2005)]
[Notices]
[Page 43934]
From the Federal Register Online via the Government Printing Office [www.gpo.gov]
[FR Doc No: 05-14975]


-----------------------------------------------------------------------

DEPARTMENT OF TRANSPORTATION

National Highway Traffic Safety Administration

[Docket No. NHTSA-2005-21930; Notice 1]


Cooper Tire & Rubber Company, Receipt of Petition for Decision of 
Inconsequential Noncompliance

    Cooper Tire & Rubber Company (Cooper) has determined that certain 
tires it produced in 2005 do not comply with S4.3(e) of 49 CFR 571.109, 
Federal Motor Vehicle Safety Standard (FMVSS) No. 109, ``New pneumatic 
tires.'' Cooper has filed an appropriate report pursuant to 49 CFR part 
573, ``Defect and Noncompliance Reports.''
    Pursuant to 49 U.S.C. 30118(d) and 30120(h), Cooper has petitioned 
for an exemption from the notification and remedy requirements of 49 
U.S.C. chapter 301 on the basis that this noncompliance is 
inconsequential to motor vehicle safety.
    This notice of receipt of Cooper's petition is published under 49 
U.S.C. 30118 and 30120 and does not represent any agency decision or 
other exercise of judgment concerning the merits of the petition.
    Cooper produced approximately 3,070 Cooper brand tires during the 
period from January 30, 2005 through May 21, 2005 that do not comply 
with FMVSS No. 109, S4.3(e). S4.3(e) of FMVSS No. 109 requires that 
``each tire shall have permanently molded into or onto both sidewalls * 
* * (e) Actual number of plies in the sidewall, and the actual number 
of plies in the tread area if different.'' The noncompliant tires were 
marked ``tread 1 ply nylon + 2 ply steel + 1 ply polyester; sidewall 2 
ply polyester.'' The correct marking should read ``tread 1 ply nylon, 2 
ply steel + 2 ply polyester; sidewall 2 ply polyester.''
    Cooper believes that the noncompliance is inconsequential to motor 
vehicle safety and that no corrective action is warranted. Cooper 
states that ``the incorrect number of tread plies on each tire does not 
present a safety-related defect. The subject tires, in fact, have 2 
polyester tread plies.'' Cooper states that the tires comply with all 
other requirements of FMVSS No. 119.
    Interested persons are invited to submit written data, views, and 
arguments on the petition described above. Comments must refer to the 
docket and notice number cited at the beginning of this notice and be 
submitted by any of the following methods. Mail: Docket Management 
Facility, U.S. Department of Transportation, Nassif Building, Room PL-
401, 400 Seventh Street, SW., Washington, DC, 20590-0001. Hand 
Delivery: Room PL-401 on the plaza level of the Nassif Building, 400 
Seventh Street, SW., Washington, DC. It is requested, but not required, 
that two copies of the comments be provided. The Docket Section is open 
on weekdays from 10 a.m. to 5 p.m. except Federal holidays. Comments 
may be submitted electronically by logging onto the Docket Management 
System Web site at https://dms.dot.gov. Click on ``Help'' to obtain 
instructions for filing the document electronically. Comments may be 
faxed to 1-202-493-2251, or may be submitted to the Federal eRulemaking 
Portal: go to https://www.regulations.gov. Follow the online 
instructions for submitting comments.
    The petition, supporting materials, and all comments received 
before the close of business on the closing date indicated below will 
be filed and will be considered. All comments and supporting materials 
received after the closing date will also be filed and will be 
considered to the extent possible. When the petition is granted or 
denied, notice of the decision will be published in the Federal 
Register pursuant to the authority indicated below.
    Comment closing date: August 29, 2005.

    Authority: 49 U.S.C. 30118, 30120: delegations of authority at 
CFR 1.50 and 501.8.

    Issued on: July 22, 2005.
Ronald L. Medford,
Senior Associate Administrator for Vehicle Safety.
[FR Doc. 05-14975 Filed 7-28-05; 8:45 am]
BILLING CODE 4910-59-P
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.