Wyoming Administrative Code
Agency 053 - Workforce Services, Department of
Sub-Agency 0025 - OSHA - General Industry 1910
Chapter 17 - WELDING, CUTTING, AND BRAZING (Q)
Subpart Q - Welding, Cutting, and Brazing
Section 17-1 - Incorporation by Reference

Universal Citation: WY Code of Rules 17-1

Current through September 21, 2024

(a) The Department of Workforce Services has determined that incorporation of the full text of these rules would be cumbersome and inefficient given the length or nature of the rules;

(b) Any code, standard, rule or regulation incorporated by reference does not include any later amendments or editions of the incorporated matter beyond the applicable date identified in subsection (d) of this section; and

(c) The incorporated code, standard, rule, or regulation is maintained at the Department of Workforce Services, OSHA Division's office (1510 East Pershing Boulevard, Cheyenne, WY 82002) and is available for public inspection and copying at cost at the same location.

(d) Each rule incorporated by reference is further identified as follows:

(i) 29 C.F.R. §§ 1910.251- 1910.255 (2016) as it was in effect on June 19, 2018 and adopted by the Department of Workforce Services, Wyoming OSHA Commission, found at:

https://www.osha.gov/pls/oshaweb/owadisp.show_document?p_table=STANDARDS&p_id=9852

Disclaimer: These regulations may not be the most recent version. Wyoming may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.