Wyoming Administrative Code
Agency 010 - Agriculture, Dept. of
Sub-Agency 0005 - General Agency, Board or Commission Rules
Chapter 52 - Wyoming Petroleum and Antifreeze Products Standards and Regulations
Section 52-4 - Standards of Quality
Universal Citation: WY Code of Rules 52-4
Current through September 21, 2024
(a) Exceptions to ASTM standards for fuel oil:
(i) ASTM grades
No. 1 and No. 2 shall not have a flash point lower than one hundred fifteen
degrees Fahrenheit (115@ F).
(ii)
ASTM grades No. 4, No. 5 and No. 6 shall not exceed one and one-half percent
(1.5%) sulfur by weight.
(b) Exceptions to ASTM standards for diesel fuel:
(i) ASTM grade No. 1 shall be a clear
product free of water and sediment.
(c) Exceptions to ASTM standards for gasoline:
(i) Gasoline shall be a clear
homogeneous liquid free of water and sediment;
(ii) The minimum lead content for gasoline
labeled "regular" or "leaded" shall be as defined in Section
2.(e) of this chapter.
(iii) Requirements imposed by the EPA shall
take precedence over ASTM standards, where applicable.
(iv) The allowable reductions in vehicle anti
knock requirements for altitude are 4.5 for less than 89 Antiknock Index (AKI),
and 3.0 for greater than 89 AKI. Fuel may be marketed using these reductions,
but actual AKI minimum must be posted.
(d) Exceptions to ASTM standards for kerosene:
(i) Kerosene shall be free of water
and suspended material.
(ii)
Kerosene shall have a color no darker than No. 16 Saybolt.
(iii) Kerosene shall have a flash point not
lower than one hundred fifteen degrees Fahrenheit (115@ F).
Disclaimer: These regulations may not be the most recent version. Wyoming may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
