Wisconsin Administrative Code
Department of Natural Resources
NR 600-699 - Environmental Protection - Hazardous Waste Management
Chapter NR 679 - Used Oil Management Standards
Subchapter F - Standards for Used Oil Processors and Re-Refiners
Section NR 679.55 - Analysis plan
Universal Citation: WI Admin Code ยง NR 679.55
Current through August 26, 2024
Owners or operators of used oil processing and re-refining facilities shall develop and follow a written analysis plan describing the procedures that will be used to comply with the analysis requirements of s. NR 679.53 and, if applicable, s. NR 679.72. The owner or operator shall keep the plan at the facility.
(1) REBUTTABLE PRESUMPTION FOR USED OIL IN S. NR 679.53. At a minimum, the plan shall specify all of the following:
(a) Whether sample analyses or
knowledge of the halogen content of the used oil will be used to make this
determination.
(b) If sample
analyses are used to make this determination, all of the following:
1. The sampling method used to obtain
representative samples to be analyzed. A representative sample may be obtained
using one of the following:
a. One of the
sampling methods in ch. NR 661 Appendix I.
b. A method shown to be equivalent under ss.
NR 660.20 and
660.21.
2. The frequency of sampling to be performed,
and whether the analysis will be performed on-site or off-site.
3. The methods used to analyze used oil for
the parameters specified in s.
NR 679.53.
(c) The type of information that will be used
to determine the halogen content of the used oil.
(2) ON-SPECIFICATION USED OIL FUEL IN S. NR 679.72. At a minimum, the plan shall specify all of the following if s. NR 679.72 is applicable:
(a) Whether sample analyses or other
information will be used to make this determination.
(b) If sample analyses are used to make this
determination, all of the following:
1. The
sampling method used to obtain representative samples to be analyzed. A
representative sample may be obtained using one of the following:
a. One of the sampling methods in ch. NR 661
Appendix I.
b. A method shown to be
equivalent under ss.
NR 660.20 and
660.21.
2. Whether used oil will be sampled and
analyzed prior to or after any processing or re-refining.
3. The frequency of sampling to be performed,
and whether the analysis will be performed on-site or off-site.
4. The methods used to analyze used oil for
the parameters specified in s.
NR 679.72.
(c) The type of information that will be used
to make the on-specification used oil fuel determination.
Disclaimer: These regulations may not be the most recent version. Wisconsin may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
