Current through August 26, 2024
If your facility has equipment to which subch. BB of ch. NR
664 applies, keep the following information at your facility:
(1) For each piece of equipment to which
subch. BB of ch. NR 664 applies:
(a) Equipment
identification number and hazardous waste management unit
identification.
(b) Approximate
locations within the facility (for example, identify the hazardous waste
management unit on a facility plot plan).
(c) Type of equipment (for example, a pump or
a pipeline valve).
(d) Percent by
weight of total organics in the hazardous waste stream at the
equipment.
(e) Hazardous waste
state at the equipment (for example, gas, vapor, or liquid).
(f) Method of compliance with the standard
(for example, monthly leak detection and repair or equipped with dual
mechanical seals).
(2)
For facilities that cannot install a closed-vent system and control device to
comply with subch. BB of ch. NR 664 on the effective date that the facility
becomes subject to the subch. BB of ch. NR 664 provisions, an implementation
schedule as specified in s.
NR 664.1033(1) (b).
(3) Documentation that demonstrates
compliance with the equipment standards in ss. NR 6264.1052 and 664.1059. This
documentation shall contain the records required under s.
NR 664.1064.
(4) Documentation to demonstrate compliance
with s.
NR 664.1060 shall include the following information:
(a) A list of all information references and
sources used in preparing the documentation.
(b) Records, including the dates, of each
compliance test required by s.
NR 664.1033(10).
(c) A design analysis, specifications,
drawings, schematics and piping and instrumentation diagrams based on the
appropriate sections of "Course 415: Control of Gaseous Emissions,"
incorporated by reference in s.
NR 660.11, or other engineering texts acceptable to the
department that present basic control device design information. The design
analysis shall address the vent stream characteristics and control device
operation parameters as specified in s.
NR 664.1035(2) (d)
3.
(d) A statement signed and dated by the owner
or operator certifying that the operating parameters used in the design
analysis reasonably represent the conditions that exist when the hazardous
waste management unit is operating at the highest load or capacity level
reasonable expected to occur.
(e) A
statement signed and dated by the owner or operator certifying that the control
device is designed to operate at an efficiency of 95 weight percent or
greater.
