Current through August 26, 2024
Except as otherwise provided in s.
NR 664.0001, owners and operators of facilities that have
process vents to which subch. AA of ch. NR 664 applies shall provide all of the
following additional information:
(1)
For facilities that cannot install a closed-vent system and control device to
comply with subch. AA of ch. NR 664 on the effective date that the facility
becomes subject to subch. AA of ch. NR 664 or subch. AA of ch. NR 665, an
implementation schedule as specified in s.
NR 664.1033(1) (b).
(2) Documentation of compliance with the
process vent standards in s.
NR 664.1032, including all of the following:
(a) Information and data identifying all
affected process vents, annual throughput and operating hours of each affected
unit, estimated emission rates for each affected vent and for the overall
facility (i.e., the total emissions for all affected vents at the facility),
and the approximate location within the facility of each affected unit (e.g.,
identify the hazardous waste management units on a facility plot
plan).
(b) Information and data
supporting estimates of vent emissions and emission reduction achieved by
add-on control devices based on engineering calculations or source tests. For
the purpose of determining compliance, estimates of vent emissions and emission
reductions shall be made using operating parameter values (e.g., temperatures,
flow rates or concentrations) that represent the conditions that exist when the
waste management unit is operating at the highest load or capacity level
reasonably expected to occur.
(c)
Information and data used to determine whether or not a process vent is subject
to s.
NR 664.1032.
(3) Where an owner or operator applies for
permission to use a control device other than a thermal vapor incinerator,
catalytic vapor incinerator, flare, boiler, process heater, condenser or carbon
adsorption system to comply with s.
NR 664.1032, and chooses to use test data to determine
the organic removal efficiency or the total organic compound concentration
achieved by the control device, a performance test plan as specified in s.
NR 664.1035(2)
(c).
(4) Documentation of compliance with s.
NR 664.1033, including all of the following:
(a) A list of all information references and
sources used in preparing the documentation.
(b) Records, including the dates, of each
compliance test required by s.
NR 664.1033(11).
(c) A design analysis, specifications,
drawings, schematics and piping and instrumentation diagrams based on the
appropriate sections of APTI Course 415: Control of Gaseous Emissions,
incorporated by reference in s.
NR 660.11, or other engineering texts acceptable to the
department that present basic control device design information. The design
analysis shall address the vent stream characteristics and control device
operation parameters as specified in s.
NR 664.1035(2) (d)
3.
(d) A statement signed and dated by the owner
or operator certifying that the operating parameters used in the design
analysis reasonably represent the conditions that exist when the hazardous
waste management unit is or would be operating at the highest load or capacity
level reasonably expected to occur.
(e) A statement signed and dated by the owner
or operator certifying that the control device is designed to operate at an
efficiency of 95 weight % or greater unless the total organic emission limits
of s.
NR 664.1032(1) for affected process
vents at the facility can be attained by a control device involving vapor
recovery at an efficiency less than 95 weight %.
