Wisconsin Administrative Code
Department of Natural Resources
NR 600-699 - Environmental Protection - Hazardous Waste Management
Chapter NR 667 - Standards For Owners And Operators Of Hazardous Waste Facilities Operating Under A Standardized License
Subchapter B - General Facility Standards
Section NR 667.0013 - What are the waste analysis requirements?

Universal Citation: WI Admin Code ยง NR 667.0013

Current through August 26, 2024

(1) Before treating or storing any hazardous wastes, obtain a detailed chemical and physical analysis of a representative sample of the wastes. At a minimum, the analysis shall contain all the information needed to treat or store the waste to comply with this chapter and ch. NR 668.

(a) You may include data in the analysis that was developed under ch. NR 661, and published or documented data on the hazardous waste or on hazardous waste generated from similar processes.

(b) Repeat the analysis as necessary to ensure that it is accurate and up to date. At a minimum, repeat the analysis if the process or operation generating the hazardous wastes has changed.

(2) Develop and follow a written waste analysis plan that describes the procedures you will follow to comply with sub. (1). Keep the waste analysis plan at the facility. If you receive wastes generated from off-site and are eligible for a standardized license, you also shall have submitted the waste analysis plan with the notice of intent. At a minimum, the plan shall specify all of the following:

(a) The hazardous waste parameters that you will analyze and the rationale for selecting these parameters (that is, how analysis for these parameters will provide sufficient information on the waste's properties to comply with sub. (1)).

(b) The test methods you will use to test for these parameters.

(c) The sampling method you will use to obtain a representative sample of the waste to be analyzed. You may obtain a representative sample using either:
1. One of the sampling methods described in ch. NR 661 Appendix I.

2. An equivalent sampling method.

(d) How frequently you will review or repeat the initial analysis of the waste to ensure that the analysis is accurate and up to date.

(e) Where applicable, the methods you will use to meet the additional waste analysis requirements for specific waste management methods as specified in ss. NR 664.0017, 664.1034(4), 664.1063(4), and 664.1083.

Disclaimer: These regulations may not be the most recent version. Wisconsin may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.