Washington Administrative Code
Title 246 - Health, Department of
FACILITY STANDARDS AND LICENSING
Chapter 246-359 - Temporary worker housing construction standard
Section 246-359-740 - Drain connector to factory assembled structures (FAS)
Universal Citation: WA Admin Code 246-359-740
Current through Register Vol. 24-18, September 15, 2024
(1) A FAS containing plumbing fixtures must be connected to the drain inlet by a drain connector:
(a)Approved by the department of
health;
(b) Consisting of pipe not
less than Schedule 40 with appropriate fittings and connectors; and
(c)Not less in size than the FAS
outlet.
(2) The fitting connected to the drain inlet must be a directional fitting to discharge the flow into the drain inlet.
(3)A drain connector must be:
(a) Installed and
maintained with a grade not less than one-fourth inch per foot;
(b)Gas-tight and no longer than necessary to
make the direct connection between the mobile home outlet and drain inlet at
the site.
(4)Each drain inlet must be maintained gas-tight when not in use.
Statutory Authority: RCW 70.114A.081. 99-03-065, § 246-359-740, filed 1/18/99, effective 2/18/99.
Disclaimer: These regulations may not be the most recent version. Washington may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
