Virginia Administrative Code
Title 9 - ENVIRONMENT
Agency 5 - STATE AIR POLLUTION CONTROL BOARD
Chapter 45 - CONSUMER AND COMMERCIAL PRODUCTS
Part II - Emission Standards
Article 6 - Emission Standards for Adhesives and Sealants
Section 9VAC5-45-680 - Administrative requirements

Universal Citation: 9 VA Admin Code 9VAC5-45-680

Current through Register Vol. 41, No. 3, September 23, 2024

Each manufacturer of an adhesive, sealant, adhesive primer, or sealant primer subject to the provisions of this article shall display the following information on the product container or label:

1. A statement of the manufacturer's recommendation regarding thinning, reducing, or mixing of the product, except that:

a. This requirement does not apply to the thinning of a product with water; and

b. If thinning of the product prior to use is not necessary, the recommendation must specify that the product is to be applied without thinning.

2. The maximum or the actual VOC content of the product as supplied, determined in accordance with 9VAC5-45-710, displayed in grams of VOC per liter of product.

3. The maximum or the actual VOC content of the product as applied (which includes the manufacturer's maximum recommendation for thinning), determined in accordance with 9VAC5-45-710, displayed in grams of VOC per liter of product.

Statutory Authority

§ 10.1-1308 of the Code of Virginia.

Disclaimer: These regulations may not be the most recent version. Virginia may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.