Virginia Administrative Code
Title 9 - ENVIRONMENT
Agency 5 - STATE AIR POLLUTION CONTROL BOARD
Chapter 40 - EXISTING STATIONARY SOURCES
Part II - Emission Standards
Article 29 - Emission Standards for Can Coating Application Systems (Rule 4-29)
Section 9VAC5-40-4040 - Control technology guidelines

Universal Citation: 9 VA Admin Code 9VAC5-40-4040

Current through Register Vol. 41, No. 3, September 23, 2024

A. Sheet basecoat (exterior and interior) and overvarnish; two-piece can exterior (basecoat and overvarnish). The control technology should consist of one or more of the following:

1. Use of electrodeposited waterborne coatings;

2. Use of ultraviolet coatings;

3. Use of high solids coatings;

4. Carbon adsorption; and

5. Incineration; or

6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 A 1, provided such technology is approved by the board.

B. Two-piece and three-piece can interior body spray; two-piece can exterior end (spray or roll coat). The control technology should consist of one or more of the following:

1. Use of waterborne coatings;

2. Use of powder coatings;

3. Use of high-solids coatings;

4. Carbon adsorption; and

5. Incineration; or

6. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 B 1, provided such technology is approved by the board.

C. Three-piece can side-seam spray. The control technology should consist of one or more of the following:

1. Use of waterborne coatings;

2. Use of powder coatings; and

3. Use of high solids coatings; or

4. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 C 1, provided such technology is approved by the board.

D. End sealing compound coating. The control technology should consist of one or more of the following:

1. Use of waterborne coatings;

2. Use of high-solids coatings; or

3. Any technology of equal or greater control efficiency when compared to the use of coating complying with 9VAC5-40-4030 D 1, provided such technology is approved by the board.

Statutory Authority

§§ 10.1-1307 and 10.1-1308 of the Code of Virginia.

Disclaimer: These regulations may not be the most recent version. Virginia may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.