Virginia Administrative Code
Title 9 - ENVIRONMENT
Agency 25 - STATE WATER CONTROL BOARD
Chapter 151 - VIRGINIA POLLUTANT DISCHARGE ELIMINATION SYSTEM (VPDES) GENERAL PERMIT REGULATION FOR DISCHARGES OF STORMWATER ASSOCIATED WITH INDUSTRIAL ACTIVITY
Part IV - Sector Specific Permit Requirements
Section 9VAC25-151-140 - Sector F - Primary metals

Universal Citation: 9 VA Admin Code 25-151-140

Current through Register Vol. 41, No. 3, September 23, 2024

A. Discharges covered under this section. The requirements listed under this section apply to stormwater discharges associated with industrial activity from the following types of facilities in the primary metal industry, and generally described by the SIC codes shown:

1. Steel works, blast furnaces, and rolling and finishing mills, including steel wire drawing and steel nails and spikes; cold-rolled steel sheet, strip, and bars; and steel pipes and tubes (SIC Codes 3312-3317).

2. Iron and steel foundries, including gray and ductile iron, malleable iron, steel investment, and steel foundries not elsewhere classified (SIC Codes 3321-3325).

3. Rolling, drawing, and extruding of nonferrous metals, including rolling, drawing, and extruding of copper; rolling, drawing, and extruding of nonferrous metals except copper and aluminum; and drawing and insulating of nonferrous wire (SIC Codes 3351-3357).

4. Nonferrous foundries (castings), including aluminum die-castings, nonferrous die-castings, except aluminum, aluminum foundries, copper foundries, and nonferrous foundries, except copper and aluminum (SIC Codes 3363-3369).

B. Benchmark monitoring and reporting requirements. Primary metals facilities are required to monitor their stormwater discharges for the pollutants of concern listed in Table 140.

Table 140

Sector F - Benchmark Monitoring Requirements

Pollutants of Concern

Benchmark Concentration

Steel Works, Blast Furnaces, and Rolling and Finishing Mills (SIC Codes 3312-3317)

Total Recoverable Aluminum

1,100 µg/L

Total Recoverable Zinc

120 µg/L

Iron and Steel Foundries (SIC Codes 3321-3325)

Total Recoverable Aluminum

1,100 µg/L

Total Suspended Solids (TSS)

100 mg/L

Total Recoverable Copper

13 µg/L

Total Recoverable Zinc

120 µg/L

Rolling, Drawing, and Extruding of Nonferrous Metals (SIC Codes 3351-3357)

Total Recoverable Copper

13 µg/L

Total Recoverable Zinc

120 µg/L

Nonferrous Foundries (SIC Codes 3363-3369)

Total Recoverable Copper

13 µg/L

Total Recoverable Zinc

120 µg/L

Statutory Authority: § 62.1-44.15 of the Code of Virginia; § 402 of the Clean Water Act; 40 CFR Parts 122, 123, and 124.

Disclaimer: These regulations may not be the most recent version. Virginia may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.