Utah Administrative Code
Topic - Environmental Quality
Title R315 - Waste Management and Radiation Control, Waste Management
Rule R315-261 - General Requirements - Identification and Listing of Hazardous Waste
Section R315-261-1060 - Air Emission Standards: Closed-Vent Systems and Control Devices
Universal Citation: UT Admin Code R 315-261-1060
Current through Bulletin 2024-06, March 15, 2024
(a) The remanufacturer or other person that stores or treats the hazardous secondary material in a hazardous secondary material management units using closed-vent systems and control devices subject to Sections R315-261-1050 through 1064 shall comply with the provisions of Section R315-261-1033.
(b)
(1) The
remanufacturer or other person that stores or treats the hazardous secondary
material at an existing facility who cannot install a closed-vent system and
control device to comply with the provisions of Sections
R315-261-1050
through 1064 on the effective date that the facility becomes subject to the
provisions of Sections
R315-261-1050
through 1064 shall prepare an implementation schedule that includes dates by
which the closed-vent system and control device shall be installed and in
operation. The controls shall be installed as soon as possible, but the
implementation schedule may allow up to 30 months after the effective date that
the facility becomes subject to Sections
R315-261-1050
through 1064 for installation and startup.
(2) Any unit that begins operation after the
effective date of rule R315-261 and is subject to the provisions of Sections
R315-261-1050
through 1064 when operation begins, shall comply with the rules immediately,
i.e., shall have control devices installed and operating on startup of the
affected unit; the 30-month implementation schedule does not apply.
(3) The remanufacturer or other person that
stores or treats the hazardous secondary material at any facility in existence
on the effective date of a statutory or regulatory amendment that renders the
facility subject to Sections
R315-261-1050
through 1064 shall comply with all requirements of Sections
R315-261-1050
through 1064 as soon as practicable but no later than 30 months after the
amendment's effective date. When control equipment required by Sections
R315-261-1050
through 1064 cannot be installed and begin operation by the effective date of
the amendment, the facility owner or operator shall prepare an implementation
schedule that includes the following information: Specific calendar dates for
award of contracts or issuance of purchase orders for the control equipment,
initiation of on-site installation of the control equipment, completion of the
control equipment installation, and performance of any testing to demonstrate
that the installed equipment meets the applicable standards of Sections
R315-261-1050
through 1064. The remanufacturer or other person that stores or treats the
hazardous secondary material shall keep a copy of the implementation schedule
at the facility.
(4)
Remanufacturers or other persons that store or treat the hazardous secondary
materials at facilities and units that become newly subject to the requirements
of Sections
R315-261-1050
through 1064 after the effective date of Rule R315-261, due to an action other
than those described in Subsection R315-261-1060(b)(3) shall comply with all
applicable requirements immediately, i.e., shall have control devices installed
and operating on the date the facility or unit becomes subject to Sections
R315-261-1050
through 1064; the 30-month implementation schedule does not
apply.
Disclaimer: These regulations may not be the most recent version. Utah may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.