Utah Administrative Code
Topic - Environmental Quality
Title R307 - Air Quality
Rule R307-306 - PM10 Nonattainment and Maintenance Areas: Abrasive Blasting
Section R307-306-6 - Performance Standards
Universal Citation: UT Admin Code R 307-306-6
Current through Bulletin 2024-06, March 15, 2024
(1) To satisfy the requirements of R307-306-4(2), the abrasive blasting operation shall use at least one of the following performance standards:
(a) confined blasting;
(b) wet abrasive blasting;
(c) hydroblasting; or
(d) unconfined blasting using abrasives as
defined in (2) below.
(2) Abrasives.
(a) Abrasives used for dry unconfined
blasting referenced in (1) above shall comply with the following performance
standards:
(i) Before blasting, the abrasive
shall not contain more than 1% by weight material passing a #70 U.S. Standard
sieve.
(ii) After blasting the
abrasive shall not contain more than 1.8% by weight material 5 microns or
smaller.
(b) Abrasives
reused for dry unconfined blasting are exempt from (a)(ii) above, but must
conform with (a)(i) above.
(3) Abrasive Certification. Sources using the performance standard of (1)(d) above to meet the requirements of R307-306-4(2) must demonstrate they have obtained abrasives from a supplier who has certified (submitted test results) to the director at least annually that such abrasives meet the requirements of (2) above.
Disclaimer: These regulations may not be the most recent version. Utah may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
