Current through Reg. 49, No. 52; December 27, 2024
(a) Wastewater and
water supply.
(1) Wastewater. An existing
large Type B assisted living facility must ensure wastewater and sewage are
discharged into a sewerage system or an onsite sewerage facility approved by
the Water Quality Division of the Texas Commission on Environmental Quality
(TCEQ), or to a system regulated by an entity responsible for water quality in
that jurisdiction as approved by the Water Quality Division of TCEQ.
(2) Water supply. An existing large Type B
assisted living facility must ensure the water supply is of safe, sanitary
quality, suitable for use, adequate in quantity and pressure, and obtained from
a public or private water supply system or a private well.
(b) Resident-use plumbing fixtures.
(1) Water closets and lavatories.
(A) An existing large Type B assisted living
facility must provide at least one water closet and one lavatory for each six
residents and for each additional resident fewer than six. Multiple toilets in
a single space must comply with paragraph (2)(B) of this subsection.
(B) An existing large Type B assisted living
facility must ensure a lavatory is readily accessible to each water
closet.
(C) An existing large Type
B assisted living facility must provide at least one water closet, lavatory,
and bathing unit, that are accessible to residents, on each floor containing
resident sleeping rooms.
(2) Bathing units.
(A) An existing large Type B assisted living
facility must provide one tub or shower for every 10 residents, and for any
fraction thereof.
(B) Where
multiple water closets or bathing units are provided in a single space, an
existing large Type B assisted living facility must provide partitions or
curtains to separate plumbing fixtures for resident privacy.
(C) An existing large Type B assisted living
facility must ensure tubs and showers have non-slip bottoms or floor surfaces,
either built-in or applied to the surfaces.
(3) Hot water supply. An existing large Type
B assisted living facility must provide a supply of hot water for resident-use.
Hot water for lavatories and bathing units accessible to residents must be
maintained between 100 and 120 degrees Fahrenheit.
(4) Supplies. An existing large Type B
assisted living facility must supply towels, soap, and toilet tissue for
individual resident use.
(c) Public and staff-use plumbing fixtures.
In addition to the staff toilets required for the dietary staff according to
§553.142(j) of this division (relating to Space Planning and Utilization
Requirements for an Existing Large Type B Assisted Living Facility), a new
large Type B assisted living facility must provide toilets, including water
closets and lavatories, for use by the public and by facility staff, as
follows:
(1) if licensed for 60 or fewer
residents, a toilet for use by the public and by facility staff; or
(2) if licensed for more than 60 residents, a
toilet for use by the public and a separate toilet for use by facility
staff.
(d) Gas. An
existing large Type B assisted living facility must ensure equipment using
natural gas or propane and related gas piping meets the requirements of 9.1.1,
Gas, in NFPA 101, Chapter 9, Building Service and Fire Protection
Equipment.
(e) Heating,
ventilation, and air-conditioning (HVAC) and exhaust systems.
(1) General requirements. An existing large
Type B assisted living facility must ensure HVAC equipment meets the
requirements of 19.5.2, Heating, Ventilating and Air-Conditioning, in NFPA 101,
Chapter 19, Existing Health Care Occupancies.
(2) Heating and cooling. An existing large
Type B assisted living facility must provide heating and cooling for resident
comfort.
(A) An existing large Type B assisted
living facility must ensure air conditioning systems can maintain and do
maintain the comfort range of 68 to 82 degrees Fahrenheit in resident-use
areas.
(B) An existing large Type B
assisted living facility constructed or licensed after August 1, 2004, must
have a central air conditioning system, or a substantially similar air
conditioning system, that can maintain and does maintain a temperature range
required under subparagraph (A) of this paragraph within areas used by
residents.
(C) An existing large
Type B assisted living facility may not use an open flame heating device in the
facility, except as permitted by subparagraphs (D) - (E) of this
paragraph.
(D) An existing large
Type B assisted living facility must ensure a fuel-fired heating device, other
than a working fireplace, meets the following requirements.
(i) A fuel-fired heating device must be
connected to a chimney or vent.
(ii) A fuel-fired heating device must take
air for combustion directly from outside.
(iii) A fuel-fired heating device must be
designed and installed to provide for complete separation of the combustion
system from the atmosphere of the occupied area.
(iv) A fuel-fired heating device must have
safety features to immediately stop the flow of fuel and shut down the
equipment in case of either excessive temperatures or ignition
failure.
(v) A fuel-fired heating
device not meeting the requirements of clauses (i) - (iv) of this subparagraph
may be continued in service, subject to approval by HHSC.
(E) An existing large Type B assisted living
facility must ensure a working fireplace meets the following requirements.
(i) A building containing a working fireplace
must be protected by an approved, supervised automatic sprinkler system with
listed quick response or listed residential sprinklers.
(ii) A new working fireplace must be
installed, maintained and used according to NFPA 54 and NFPA 211.
(iii) A working fireplace may not be located
in a resident sleeping room.
(iv)
The room where a working fireplace is located must be provided with
electrically supervised carbon monoxide detection connected to the fire alarm
system according to NFPA 720.
(v) A
direct-vent gas fireplace, as defined in NFPA 54, must meet the following
requirements.
(I) A direct-vent gas fireplace
must include a sealed glass front with a wire mesh panel or screen.
(II) The controls for a direct-vent gas
fireplace must be locked or located in a restricted location.
(vi) A solid-fuel burning must be
equipped with:
(I) a raised hearth at least
four inches above the surrounding finished floor; and
(II) a fireplace enclosure that is guaranteed
against breakage up to a temperature of 650 degrees Fahrenheit and constructed
of heat-tempered glass or other approved material.
(vii) An existing working fireplace not
meeting the requirements of clauses (i) - (vi) of this subparagraph may be
continued in service, subject to approval by HHSC.
(3) Ventilation.
(A) An existing large Type B assisted living
facility must be ventilated using windows or mechanical ventilation, or a
combination of both.
(B) An
existing large Type B assisted living facility with interior areas designated
for smoking within the building must provide mechanical ventilation directed to
the exterior to remove smoke at the rate of 10 air changes per hour.
(4) Exhaust. An existing large
Type B assisted living facility must ensure bathrooms, toilet rooms, janitorial
facilities, and other odor-producing rooms or areas for soiled or unsanitary
operations are exhausted with operable windows or powered exhaust vented to the
exterior for odor control.