Texas Administrative Code
Title 16 - ECONOMIC REGULATION
Part 1 - RAILROAD COMMISSION OF TEXAS
Chapter 4 - ENVIRONMENTAL PROTECTION
Subchapter B - COMMERCIAL RECYCLING
Division 4 - REQUIREMENTS FOR STATIONARY COMMERCIAL SOLID OIL AND GAS WASTE RECYCLING FACILITIES
Section 4.248 - Minimum Siting Information
Universal Citation: 16 TX Admin Code § 4.248
Current through Reg. 50, No. 13; March 28, 2025
(a) A permit application for a stationary commercial solid oil and gas waste recycling facility shall include:
(1) a
description of the proposed facility site and surrounding area;
(2) the name, physical address and, if
different, mailing address, and telephone number of every owner of the tract on
which the facility is to be located. If any owner is not an individual, the
applicant shall include the name of a contact person for that owner;
(3) the depth to the shallowest subsurface
water and the direction of groundwater flow at the proposed site, and the
source of this information;
(4) the
average annual precipitation and evaporation at the proposed site and the
source of this information;
(5) the
identification of the soil and subsoil by typical name and description of the
approximate proportion of grain sizes, texture, consistency, moisture
condition, and other pertinent characteristics, and the source of this
information;
(6) a copy of a county
highway map with a scale and north arrow showing the location of the proposed
facility; and
(7) a United States
Geological Survey (USGS) topographic map or an equivalent topographic map which
shows the facility including the items listed in subparagraphs (A) - (K) of
this paragraph and any other pertinent information regarding the regulated
facility and associated activities. Maps shall be on a scale of not less than
one inch equals 2,000 feet. The map shall show the following:
(A) a scale and north arrow showing the tract
size in square feet or acres, the section/survey lines, and the survey name and
abstract number;
(B) a clear
outline of the proposed facility's boundaries;
(C) the location of any pipelines within 500
feet of the facility;
(D) the
distance from the facility's outermost perimeter boundary to public and private
water wells, residences, schools, churches, and hospitals that are within 500
feet of the boundary;
(E) for
disposal only, the location of all residential and commercial buildings within
a one-mile radius of the facility boundary;
(F) all water wells within a one-mile radius
of the facility boundary;
(G) the
location of the 100-year flood plain and the source of the flood plain
information;
(H) surface water
bodies within the map area;
(I) the
location of any major and minor aquifers within the map area;
(J) the boundaries of any prohibited areas
defined under §
4.153 of this title (relating to
Commercial Disposal Pits); and
(K)
any other information requested by the Director reasonably related to the
prevention of pollution.
(b) A pit permitted under this division is prohibited:
(1) where there has been
observable groundwater within 100 feet of the ground surface unless the pit
design includes a geosynthetic clay liner (GCL) tested using fluids likely to
be encountered in the operations of the facility and the test results
demonstrated the GCL can sustain a hydraulic conductivity of 1.0 x 10-7cm/sec
or less;
(2) within a sensitive
area as defined by §
4.110 of this title (relating to
Definitions);
(3) within 300 feet
of surface water, domestic supply wells, or irrigation water wells;
(4) within 500 feet of any public water
system wells or intakes;
(5) within
1,000 feet of a permanent residence, school, hospital, institution, or church
in existence at the time of the initial permitting;
(6) within 500 feet of a wetland;
or
(7) within a 100-year
floodplain.
(c) Factors that the Commission will consider in assessing potential risk from stationary commercial solid oil and gas waste recycling include:
(1) the volume and characteristics of the oil
and gas waste, partially treated waste and recyclable product to be stored,
handled, treated and recycled at the facility;
(2) proximity to coastal natural resources or
sensitive areas as defined by §
4.110 of this title; and
(3) any other factors the Commission deems
reasonably necessary in determining whether or not issuance of the permit will
pose an unreasonable risk.
(d) All siting requirements in this section for stationary commercial solid oil and gas waste recycling refer to conditions at the time the equipment and tanks used in the recycling are placed.
Disclaimer: These regulations may not be the most recent version. Texas may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.