South Dakota Administrative Rules
Title 74 - Department of Environment And Natural Resources
Article 74:02 - Water rights
Chapter 74:02:04 - Well construction standards
Section 74:02:04:44 - Thermoplastic casing installation requirements

Universal Citation: SD Admin Rules 74:02:04:44
Current through Register Vol. 50, page 114, March 25, 2024

The driller shall be knowledgeable of heat of hydration and thermoplastic hydraulic collapse pressure limits listed in ASTM Standard F 480-90e and the "Manual on the Selection and Installation of Thermoplastic Water Well Casing," 1980. When using thermoplastic casing to construct a well, the driller shall install the thermoplastic casing in a manner that does not exceed the casing hydraulic collapse resistance.

General Authority: SDCL 46-2-5, 46-6-20, 46-6-27.

Law Implemented: SDCL 46-6-10, 46-6-20, 46-6-27.

ASTM Standard F 480-90e, "Thermoplastic Water Well Casing Pipe and Couplings Made in Standard Dimension Ratios (SDR)," July 27, 1990. Published by American Society for Testing and Materials, September 1990. Copies may be obtained from the American Society for Testing and Materials, 1916 Race Street, Philadelphia, PA 19103; Cost: $12.

"Manual on the Selection and Installation of Thermoplastic Water Well Casing," 1980. Published by the National Water Well Association and the Plastic Pipe Institute, October 1, 1980. Copies may be obtained from the National Ground Water Association Bookstore, P.O. Box 182039, Dept. 017, Columbus, OH 43218-2039. Cost: $15.

Disclaimer: These regulations may not be the most recent version. South Dakota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.