South Dakota Administrative Rules
Title 61 - Department of Public Safety
Article 61:08 - Boilers
Chapter 61:08:09 - Historic power boilers
Section 61:08:09:18 - Hydrostatic pretest - Safety valve requirements
Universal Citation: SD Admin Rules 61:08:09:18
Current through Register Vol. 51, page 70, December 27, 2024
Each boiler must be equipped with a safety valve which will discharge all the steam that can be generated by the boiler without allowing the pressure to rise more than six percent above the MAWP. One safety valve may be set no higher than the MAWP. Safety valves must be sealed by the holder of an ASME "V" or National Board "VR" Certificate.
General Authority: SDCL 34-29A-14.1.
Law Implemented: SDCL 34-29A-14.1.
(MAWP) Maximum allowable working pressure, § 61:08:09:13.
Disclaimer: These regulations may not be the most recent version. South Dakota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
