South Carolina Code of Regulations
Chapter 61 - DEPARTMENT OF HEALTH AND ENVIRONMENTAL CONTROL
Subchapter 61-58.3 - Surface Water Sources and Treatment
Section 61-58.3.F - Waste Handling and Disposal

Universal Citation: SC Code Regs 61-58.3.F

Current through Register Vol. 48, No. 9, September 27, 2024

Waste handling and disposal practices shall meet all applicable rules and regulations of the Department. Provisions must be made for proper disposal of water treatment plant waste such as sanitary, laboratory, clarification sludge, softening sludge, iron sludge, filter backwash water, filter to waste, and brine waste. In locating waste disposal facilities, due consideration shall be given to preventing potential contamination of the water supply. For projects involving a surface water discharge of water treatment residuals or waste water, a National Pollutant Discharge Elimination System (NPDES) permit must be obtained from the Department. For projects involving land application of water treatment residuals or waste water, a No Discharge (ND) permit must be obtained from the Department.

(1) Sanitary Waste--The sanitary waste from water treatment plants, pumping stations, etc., must receive treatment. Waste from these facilities must be discharged directly to a sanitary sewer system, when feasible, or to an adequate on-site waste treatment facility.

(2) Alum Sludge--Mechanical concentration or lagooning may be used as a method of handling alum sludge. Acid treatment of sludge for alum recovery may be a possible alternative. Alum sludge can be discharged to a sanitary sewer only if acceptable to the receiving sewer system and approved by the Department before final designs are made.

(a) Lagoons shall be designed to shall meet the following requirements:
(i) A minimum of two (2) lagoons are required for handling alum sludge.

(ii) The location shall be such that the top of the dike is at least one (1) foot above the one hundred (100) year flood plain;

(iii) Where necessary, dikes, deflecting gutters or other means of diverting surface water runoff shall be provided so that it does not flow into the lagoon;

(iv) A minimum usable depth of five (5) feet with adequate freeboard shall be provided so as not to interfere with normal plant operation;

(v) Dikes shall be constructed of relatively impervious material and compacted to at least ninety (90) percent Standard Proctor Density to form a stable structure. Vegetation and other unsuitable materials shall be removed. Minimum dike width shall be eight (8) feet. Dike slopes shall not be steeper than one (1) foot vertical to three (3) feet horizontal;

(vi) A minimum separation of four (4) feet between the bottom of the lagoon and the maximum groundwater elevation shall be maintained;

(vii) A synthetic liner of at least twenty (20) mil (0.20 inches) thickness or a natural liner consisting of one foot of compacted clay having a hydraulic conductivity (coefficient of permeability) of no more than .0000001 centimeters per second shall be used;

(viii) A monitoring system shall be constructed to measure the water quality in the upper most aquifer. One (1) upgradient monitoring well and an adequate number of down gradient monitoring wells, so as to fully define any potential leacheate plume, shall be provided;

(ix) An adjustable decanting device must be provided;

(x) Effluent sampling point and flow measurement device must be provided;

(xi) Erosion control through grassing, rip-rap, or other means is required on both the inside and outside dike surfaces; and,

(xii) Adequate safety provisions must be installed.

(b) Mechanical concentration or de-watering--A pilot study is required before the design of a mechanical de-watering installation. Provisions shall be made for holding basins so as to maintain continuity of service of the water plant. Vacuum filters, centrifuges, filter presses, belt presses, or other devices will be considered.

(3) Lime softening sludge--Methods of treatment and disposal are as follows:

(a) Lagoons
(i) Temporary lagoons which must be cleaned periodically shall be designed on the basis of seven tenths (0.7) acres per million gallons per day per one hundred (100) milligrams per liter of hardness removed based on a usable lagoon depth of five (5) feet. At least two (2) lagoons must be provided in order to give flexibility in operation. An acceptable means of final sludge disposal must be provided. Provisions must be made for convenient cleaning.

(ii) Permanent lagoons shall have a volume of at least four (4) times that for temporary lagoons.

(iii) The design of both temporary lagoons and permanent lagoons shall meet the requirements for lagoons in paragraph 2(a) above.

(b) Discharge of lime sludge to sanitary sewers shall be avoided if possible since it may cause both liquid volume and sludge volume problems at the sewage treatment plant. This method shall be used only when the sewer system has the capability to adequately handle the lime sludge and is acceptable to both the sewer system and the Department.

(c) Mechanical de-watering of sludge may be considered. Pilot studies on a particular plant waste are required.

(d) Calcination of sludge may be considered. Pilot studies on a particular plant waste are required.

Disclaimer: These regulations may not be the most recent version. South Carolina may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.