South Carolina Code of Regulations
Chapter 49 - DEPARTMENT OF LABOR, LICENSING AND REGULATION- SOUTH CAROLINA STATE BOARD OF REGISTRATION FOR PROFESSIONAL ENGINEERS AND LAND SURVEYORS
Article 4 - STANDARDS OF PRACTICE MANUAL FOR SURVEYING IN SOUTH CAROLINA
Section 49-420 - General

A. For the purpose of these regulations, the following terms or words are defined as meaning:

B. The proper execution of surveying, platting and mapping procedures and all other details of a survey are the direct responsibility of the Surveyor whose seal and signature shall appear on the plat or map to be prepared. The fact that a plat or map is approved by a planning department or accepted by Clerk of Court for recordation in no way relieves the surveyor whose seal appears upon the drawing of the full responsibility to make certain that the plat or map meets the requirements of these standards.

C. The plat or map shall remain for a period of time required by the statute of repose in the possession of the surveyor whose seal appears thereon. It should, therefore, be professionally and accurately prepared as a permanent record and after prints or copies have been made for recordation or other purposes the original plat should be carefully preserved by the surveyor or their firm along with the surveyor's original field notes, calculations, and work sheets for, at a minimum, the length of time the statute of repose applies. Such material, in original form, is to be made available when required either by the Board or by the courts.

D. The words "course" and "bearing" are used interchangeably in this manual.

E. Where survey requirements are more stringent than those set forth herein, the surveyor shall comply with those standards as mandated by federal, state, or local governmental requirements.

F. Surveys which are performed for a specific stated purpose other than boundary surveys as defined herein shall be permitted where unusual conditions make it impractical or impossible to perform the survey to the standards set forth herein, provided the purpose and conditions shall be clearly stated on the survey drawing. This section is not to be used in any way to circumvent the standards in this manual on a survey which can be performed to these standards.

G. Additions and/or deletions to survey drawings by other than the signing party or parties are prohibited without written consent of the original signing party or parties.

H. The surveyor shall comply with the minimum survey classifications noted herein but has the option to negotiate with each client an agreement for a higher classification.