Pennsylvania Code
Title 67 - TRANSPORTATION
Part I - Department of Transportation
Subpart A - Vehicle Code Provisions
Article VII - Vehicle Characteristics
Chapter 181 - HOLD-DOWN AND TIEDOWN DEVICES FOR JUNKED VEHICLES AND VEHICLE HULKS
Section 181.9 - General requirements for securement

Universal Citation: 67 PA Code ยง 181.9

Current through Register Vol. 54, No. 44, November 2, 2024

(a) Tightening. Tiedown assemblies shall be tightened by the driver before the vehicle leaves the loading area.

(b) Examination. Loads shall be examined by the driver and load securing devices shall, if necessary, be tightened or repositioned, within 10 miles after leaving the loading area and at approximately 100 mile intervals thereafter while in transit.

(c) Timber. Timber used for blocking shall be of sound lumber and shall be nominal 4 by 4 inch cross-section or more. The term "nominal" as used in this subsection to describe timber means commercially dressed sizes.

Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.