Pennsylvania Code
Title 67 - TRANSPORTATION
Part I - Department of Transportation
Subpart A - Vehicle Code Provisions
Article VII - Vehicle Characteristics
Chapter 175 - VEHICLE EQUIPMENT AND INSPECTION
Subchapter O - VEHICLE SUN SCREENING DEVICES
TABLE V - LOCATION OF REQUIRED EQUIPMENT
Universal Citation: 67 PA Code ยง TABLE V
Current through Register Vol. 54, No. 44, November 2, 2024
MOTORCYCLES
| ITEM | LOCATION ON MOTORCYCLES | Height above road surface measured from center of item on vehicle |
| Turn Signal Lamps | At or near the front 1 amber on each side of the vertical centerline at the same height, and having a minimum horizontal separation distance (centerline of lamps) of 16". Minimum edge to edge separation distance between lamp and headlamp is 4". | Not less than 15" nor more than 83" |
| At or near the rear 1 red or amber on each side of the vertical centerline, at the same height and having a minimum horizontal separation distance (centerline to centerline of lamps) of 9". Minimum edge to edge separation distance between lamp and tail or stop lamp is 4". |
This table cited in 67 Pa. Code § 175.146 (relating to lighting and electrical systems); 67 Pa. Code § 175.160 (relating to inspection procedure); 67 Pa. Code § 175.175 (relating to lighting and electrical systems); and 67 Pa. Code § 175.190 (relating to inspection procedure).
Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
