Pennsylvania Code
Title 67 - TRANSPORTATION
Part I - Department of Transportation
Subpart A - Vehicle Code Provisions
Article VII - Vehicle Characteristics
Chapter 175 - VEHICLE EQUIPMENT AND INSPECTION
Subchapter E - PASSENGER CARS AND LIGHT TRUCKS
Section 175.64 - Braking systems

Universal Citation: 67 PA Code ยง 175.64

Current through Register Vol. 54, No. 44, November 2, 2024

(a) Condition of braking systems. Braking systems and components shall be in safe operating condition as described in § 175.80 (relating to inspection procedure).

(b) Service brakes. A vehicle specified under this subchapter shall be equipped with a service brake system. See 75 Pa.C.S. § 4502 (relating to general requirements for braking systems).

(1) The service brakes shall act on all wheels upon application and shall be capable of stopping a vehicle in not more than the maximum stopping distance prescribed in Table I (relating to brake performance), except on a vehicle being transported in driveaway-towaway operation.

(2) The brake lining and brake fluids shall be of a type approved by the vehicle manufacturer or shall meet the Society of Automotive Engineers (SAE) standards in Appendix A (relating to minimum requirements for motor vehicle brake lining-SAE J998).

(3) A passenger car manufactured or assembled after June 30, 1967, and designated as a 1968 or later model shall be equipped with a service brake system of a design that rupture or failure of either the front or rear brake system will not result in the complete loss of braking function. Braking function may be obtained by hydraulic or other means through a normal brake mechanism. In the event of a rupture or failure of an actuating force component, the unaffected brakes shall be capable of applying adequate braking force to vehicle.

(4) Metal from a shoe may not contact the brake drums or rotors.

(5) Brake lines shall be approved for use as brake lines.

(c) Parking brake system. A vehicle specified under this subchapter shall be equipped with a parking brake system. See 75 Pa.C.S. § 4502.

(1) A parking brake system shall be adequate to hold the vehicle on a surface free from ice or snow on a 20% grade with the vehicle in neutral.

(2) The parking brakes shall be separately actuated so that failure of any part of the service brake actuation system will not diminish the vehicle's parking brake holding capability.

The provisions of this §175.64 amended under the Vehicle Code, 75 Pa.C.S. §§ 4103, 4301, 4501, 4521 and 6103.

Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.