Pennsylvania Code
Title 67 - TRANSPORTATION
Part I - Department of Transportation
Subpart A - Vehicle Code Provisions
Article VII - Vehicle Characteristics
Chapter 171 - SCHOOL BUSES AND SCHOOL VEHICLES
Subchapter D - ADDITIONAL STANDARDS FOR SPECIALLY EQUIPPED SCHOOL BUSES AND SCHOOL VEHICLES
Section 171.103 - Special service entrance

Universal Citation: 67 PA Code ยง 171.103

Current through Register Vol. 54, No. 44, November 2, 2024

(a) General. A special service entrance may be constructed to accommodate a wheelchair lift for the loading and unloading of passengers.

(b) Requirements for school buses. The following apply to the special service entrance on school buses:

(1) The special service entrance shall be located at a convenient point on the right-curb side-of the school bus and far enough to the rear to prevent the door, when open, from obstructing the right front service door-excluding a regular front service door lift.

(2) The opening may extend below the floor through the bottom of the body skirt. If such an opening is used, reinforcements shall be installed at the front and rear of the floor opening to support the floor and provide the same strength as other floor openings.

(3) With doors open, the minimum clear opening shall be 30 inches in width.

(4) A drip moulding shall be installed above the opening to effectively divert water from the entrance.

(5) The entrance shall be of sufficient width and depth to accommodate various mechanical lifts and related accessories as well as the lifting platform.

(6) Door posts and headers from the entrance shall be reinforced sufficiently to provide support and strength equivalent to the areas of the side of the school bus not used for service doors.

(c) Requirements for school vehicles. The following apply to the special service entrance on school vehicles:

(1) The special service entrance shall be located at a convenient point to the right-curb side or to the rear of the school vehicle.

(2) With doors open, the minimum clear opening shall be 30 inches in width.

(3) A drip molding shall be installed above the opening to effectively divert water from the entrance.

(4) The entrance shall be of sufficient width and depth to accommodate the mechanical lift and related accessories as well as the lifting platform.

(5) Door posts and headers from the entrance shall be reinforced sufficiently to provide support and strength equivalent to original manufacture.

The provisions of this §171.103 amended under the Vehicle Code, 75 Pa.C.S. §§ 4551-4553 and 6103.

Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.