Pennsylvania Code
Title 67 - TRANSPORTATION
Part I - Department of Transportation
Subpart A - Vehicle Code Provisions
Article VII - Vehicle Characteristics
Chapter 165 - SLOW-MOVING VEHICLE IDENTIFICATION EMBLEM
Section 165.7 - Mounting

Universal Citation: 67 PA Code ยง 165.7

Current through Register Vol. 54, No. 44, November 2, 2024

(a) General. Both the permanently mounted emblem and the portable emblem shall be mounted point up, see Figure 1, in a plane perpendicular to the direction of travel plus or minus 10 degrees. The emblem shall be placed centrally at the rear of the vehicle, unobscured and 2 to 6 feet (.61 to 1.83 meters) above the ground measured from the lower edge of the emblem. It may be permanently attached to equipment when practical. Portable emblems shall be mounted by using bracket sockets and identification emblem brackets specified in ASAE Standard ASAE S277, "Mounting Brackets and Socket for Agricultural and Industrial Equipment Warning Lamp and Slow-Moving Vehicle (SMV) Identification Emblem."

(b) Other devices. The emblem shall not replace such warning devices as tail lamps, reflectors, flashing lights or warning flags and is not to be used as a clearance marker for wide equipment.

Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.