Pennsylvania Code
Title 67 - TRANSPORTATION
Part I - Department of Transportation
Subpart A - Vehicle Code Provisions
Article VI - Operation of Vehicles
Chapter 105 - MECHANICAL, ELECTRICAL AND ELECTRONIC SPEED-TIMING DEVICES
Subchapter B - ELECTRONIC DEVICES (RADAR)
Section 105.14 - Required equipment
Current through Register Vol. 54, No. 44, November 2, 2024
The following equipment is required for the operation of a maintenance and calibration station. Suitable manufacturers and model numbers are listed, however, equivalent equipment or an alternative technique approved by the Communications Division, State Police is acceptable:
(1) Power supply-Hewlett Packard Model 6177C.
(2) Frequency counter-Hewlett Packard Model 5314A.
(3) Power Meter and Thermistor Mounts-Hewlett Packard Models 432A, X486A and K486A.
(4) Multimeter-Hewlett Packard Model 410C.
(5) AC Voltmeter-Hewlett Packard Model 400D or Leader Model LMV-181A.
(6) Function Generator-Hewlett Packard Model 3311A.
(7) Variable Attenuators-Hewlett Packard Models X382A and K382A.
(8) RF Absorption Chamber-See Appendix A, Figure 1.
(9) Frequency Counter-Hewlett Packard Models 5342A or 5343A.
(10) Calibrated Antennas-Narda Models 638 and 640.
(11) Coaxial Adapters-Narda Models 4601 and 4608B.
(12) Pin Diode Switch-General Microwave F9114.
(13) Microphone-Electrovoice 631A.
(14) 4 Watt HF or VHF-AM Modulated Signal Source.
(15) Base Loaded Whip Antenna Tuned to paragraph (14).
This section cited in 67 Pa. Code § 105a.4 (relating to system and speed timing device use and certification).
