Pennsylvania Code
Title 58 - RECREATION
Part II - FISH AND BOAT COMMISSION
Subpart C - BOATING
Chapter 95 - MANUFACTURER INSTALLED EQUIPMENT
Section 95.7 - Hull identification numbers

Universal Citation: 58 PA Code ยง 95.7

Current through Register Vol. 54, No. 44, November 2, 2024

(a) A person who builds a boat for his own use shall identify the boat with two hull identification numbers that meet the requirements of this section.

(b) Persons who are required to identify boats under subsection (a) shall obtain the required hull identification number from the Commission. Application shall be made on forms provided by the Commission.

(c) Two identical hull identification numbers are required to be displayed on each boat hull. The first hull identification number shall be affixed as follows:

(1) On boats with transoms, to the starboard side of the transom within 2 inches of the top of the transom gunwale or hull/deck joint, whichever is lowest.

(2) On boats without transoms or on boats on which it would be impractical to use the transom, to the starboard outboard side of the hull, aft, within 1 foot of the stern and within 2 inches of the top of the hull side, gunwale or hull/deck joint, whichever is lowest.

(3) On catamarans and pontoon boats which have readily replaceable hulls, to the aft crossbeam within 1 foot of the starboard hull attachment.

(4) If the hull identification number would not be visible because of rails, fittings or other accessories, the number shall be affixed as near as possible to the location specified in paragraph (1).

(d) The duplicate hull identification number shall be affixed in an unexposed location on the interior of the boat or beneath a fitting or item of hardware.

(e) Each hull identification number shall be carved, burned, stamped, embossed, molded, bonded or otherwise permanently affixed to the boat so that alteration, removal or replacement would be obvious. A hull identification number may not be attached to parts of the boat that are removable.

(f) The character of each hull identification number may not be less than 1/4 of an inch high.

(g) A person may not remove or alter a number required by this section or 33 CFR 181.23 (relating to hull identification numbers required) unless authorized by the Executive Director.

Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.