Pennsylvania Code
Title 34 - LABOR AND INDUSTRY
Part I - Department of Labor and Industry
Chapter 25 - LIFTING AND CARRYING APPARATUS
Subchapter B - CRANES, BOOMS AND HOISTS
GANTRY CRANES
Section 25.61 - Special requirements

Universal Citation: 34 PA Code ยง 25.61

Current through Register Vol. 54, No. 38, September 21, 2024

(a) Fenders. All bridge truck wheels shall be equipped with fenders which shall project in front of the wheels and extend slightly below the top of the rail in the same groove as the wheel flange or flanges.

(b) Passageway. An unobstructed passageway not less than 30 inches wide shall be maintained parallel to and extending the entire length of the tracks upon which any gantry crane is operated.

(c) Stairways to platforms. Where stairways are used to give access to platforms they shall be equipped with a substantial handrail.

(d) Warning device. An automatically operated bell or other effective warning device, which shall operate at all times while the crane is traveling, shall be provided on all gantry cranes. In addition, each trolley or similar part of a gantry crane shall be equipped with a manually operated bell, or other effective warning device, in all cases where persons may be endangered by the movement of a trolley or similar part.

(e) Rail stops. Rail stops shall be provided at both ends of the crane runway. The rail stops shall extend at least as high as the center of the wheels.

Disclaimer: These regulations may not be the most recent version. Pennsylvania may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.