Current through Register Vol. 54, No. 44, November 2, 2024
(a) An
application shall contain a topographic map of the proposed permit and adjacent
areas showing the following:
(1) The
boundaries of lands proposed to be affected over the estimated total life of
the proposed operation and the sequence of landfilling and closure.
(2) A change in a component of the facility
or a feature within the proposed permit area to be caused by the proposed
operation.
(3) Buildings, utility
corridors and facilities which will be used in the operation.
(4) The areas of land for which a bond will
be posted under Chapter 271, Subchapter D (relating to financial assurances
requirements).
(5) The solid waste
storage, processing or unloading areas.
(6) The water diversion, collection,
conveyance, erosion and sedimentation control, treatment, storage and discharge
facilities to be used.
(7) Location
and elevation of the permanent physical markers for the grid coordinate system
under subsection (b).
(8) The gas
management, collection and control facilities.
(9) The boundaries of construction
activities.
(10) The location of
barriers, fences and similar structures required by §
273.212 (relating to access
control).
(11) The location of each
sedimentation pond, permanent water impoundment or similar facility.
(12) The location of access roads to the
site, including slopes, grades and lengths of the roads.
(13) The location and identification of
monitoring wells.
(14) A designated
area for vehicles for use in the event of the detection of waste containing
radioactive material. The designated area shall, by location or shielding,
protect the environment, facility staff and public from radiation originating
in the vehicle. The Department's "Guidance Document on Radioactivity
Monitoring at Solid Waste Processing and Disposal Facilities,"
Document Number 250-3100-001, describes various factors to consider in
determining an appropriate designated area.
(b) The applicant shall also submit a grid
coordinate system for the entire proposed permit area. The horizontal control
system shall consist of a grid not to exceed 200-foot square sections. A
permanent benchmark for horizontal and vertical control shall be shown. The
grid system shall be tied to the benchmark and the baseline.
This section cited in 25 Pa. Code §
273.131 (relating to basic
requirements); and 25 Pa. Code §
273.132 (relating to operation
plan).
