Pennsylvania Code
Title 25 - ENVIRONMENTAL PROTECTION
Part I - Department of Environmental Protection
Subpart D - Environmental Health and Safety
Article IX - Residual Waste Management
Chapter 288 - RESIDUAL WASTE LANDFILLS
Subchapter D - ADDITIONAL REQUIREMENTS FOR CLASS I RESIDUAL WASTE LANDFILLS
ADDITIONAL OPERATING REQUIREMENTS-LINER SYSTEM
Section 288.436 - Primary liner
Current through Register Vol. 54, No. 44, November 2, 2024
(a) General. The primary liner shall meet the following requirements:
(b) Alternative design standards. Unless alternative design standards to meet the performance standards in subsection (a) are approved as part of the permit under § 287.231 (relating to equivalency review procedure), the primary liner shall meet, at the minimum, the requirements of Appendix A, Table I (relating to minimum liner design standards).
(c) Requirements. A primary liner shall:
(d) Composite primary liner.
(e) Natural attenuation of leachate prohibited. Except as provided in subsection (d), a facility or a component thereof that is subject to this section may not have a primary liner made of clay or earthen material or a primary liner based upon natural attenuation of leachate.
This section cited in 25 Pa. Code § 287.114 (relating to interim operational requirements for unpermitted processing or disposal facilities); 25 Pa. Code § 287.116 (relating to interim operational requirements); 25 Pa. Code § 288.412 (relating to liner system and leachate control plan); 25 Pa. Code § 288.421 (relating to basic limitations); 25 Pa. Code § 288.431 (relating to scope and requirements); and 25 Pa. Code § 288.434 (relating to secondary liner).