Oregon Administrative Rules
Chapter 918 - DEPARTMENT OF CONSUMER AND BUSINESS SERVICES, BUILDING CODES DIVISION
Division 261 - ELECTRICAL EXEMPTIONS
Section 918-261-0039 - Exemption for Products Located on the Load Side of a Listed Class 2 Transformer

Universal Citation: OR Admin Rules 918-261-0039

Current through Register Vol. 63, No. 9, September 1, 2024

(1) An exemption from product certification is granted under ORS 479.540 for installation of Class 2 products, other than wiring, located on the load side of a listed Class 2 transformer. The exemption applies only to products that are not:

(a) In a damp or wet location;

(b) Located in a plenum, duct or other air-handling space;

(c) Located in any area from chapter 5 of the adopted Oregon Electrical Specialty Code; or

(d) Part of a protective signaling system.

(2) An exemption from permitting is created for installation of Class 2 wiring located on the load side of a listed garage door controller. The exemption applies only to one- and two-family dwellings when the wiring is not part of the original wiring of the dwelling.

Publications: Publications referenced are available from the agency.

Stat. Auth.: ORS 479.540

Stats. Implemented: ORS 479.540

Disclaimer: These regulations may not be the most recent version. Oregon may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.