Oregon Administrative Rules
Chapter 918 - DEPARTMENT OF CONSUMER AND BUSINESS SERVICES, BUILDING CODES DIVISION
Division 225 - BOILERS AND PRESSURE VESSELS
Section 918-225-0445 - Other Installation Standards
Universal Citation: OR Admin Rules 918-225-0445
Current through Register Vol. 63, No. 12, December 1, 2024
(1) Boilers or pressure vessels not designed or constructed in accordance with the Boiler and Pressure Vessel Code of the American Society of Mechanical Engineers (ASME) may be installed in Oregon if the boiler or pressure vessel was designed or constructed in accordance with the applicable standards issued by one of the following organizations:
(a) British Standards Institute;
(b) Canadian Standards Association;
(c) European Committee for Standardization;
or
(d) Syndicat National de la
Chaudronnerie de la Tuyauterie & de la Maintenance Industrielle
(SNCT).
(2) Boilers and pressure vessels constructed in accordance with the standards listed in (1)(a) through (d) of this rule must:
(a) Have
controls and safety devices that are comparable to the controls and safety
devices outlined in ASME CSD-1, Controls and Safety Devices for Automatically
Fired Boilers, including, but not limited to, data plates and warning labels
that are written in English;
(b) Be
fitted with pressure relief valves that are built to ASME standards;
and,
(c) Be installed, operated,
maintained, and repaired in accordance with the provisions of ORS
480.510 to
480.670 and these
rules.
Stat. Auth.: ORS 480.545 & 480.560
Stats. Implemented: ORS 480.545 & 480.560
Disclaimer: These regulations may not be the most recent version. Oregon may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google
Privacy Policy and
Terms of Service apply.
