Oregon Administrative Rules
Chapter 735 - DEPARTMENT OF TRANSPORTATION, DRIVER AND MOTOR VEHICLE SERVICES DIVISION
Division 108 - LIGHTING EQUIPMENT
Section 735-108-0010 - Aiming, Wiring and Mounting of Headlights for Motor Vehicles

Universal Citation: OR Admin Rules 735-108-0010

Current through Register Vol. 63, No. 9, September 1, 2024

(1) Transportation Safety adopts aiming, wiring and mounting requirements for motor vehicle headlights.

(2) The preparation for aiming of headlights shall be by one of the following methods:

(a) Mechanical aimer method:
(A) Calibrate the aimer for accuracy according to the instructions of the manufacturer; and

(B) Make compensation for the ground level in the aiming area.

(b) Visual aiming screen method:
(A) Locate the vehicle on a level surface, under normal load condition with the driver behind the steering wheel;

(B) Locate the screen 25 feet in front of the lens of the light;

(C) Adjust the screen to the level of the area on which the vehicle stands;

(D) Align the vehicle with the screen; and

(E) Activate the automatic (air) suspension if the vehicle is so equipped.

(3) Aiming of headlights:

(a) Aim lights according to vehicle manufacturer instructions when vehicle is equipped with self contained aiming devices;

(b) Adjust headlights to a setting of 0-0 when using a mechanical aimer;

(c) Aim the center of the high intensity zone at horizontal and straight ahead vertical for high beam, and aim the top edge of the high intensity zone at horizontal and the left edge at vertical for low beam, when using a visual aiming screen; or

(d) Aim lights according to manufacturer instructions when using other methods developed by vehicle or lighting equipment manufacturers for use on new vehicle and/or headlight designs. These methods are acceptable if they meet federal and/or SAE requirements.

(4) Wire headlights to meet the following:

(a) When headlights are turned on the taillights, clearance lights and marker lights will be illuminated;

(b) When vehicle is parked, the headlights can be turned off but permits parking lights to be turned on; and

(c) Headlights may alternate between high and low beams by means of a switch used at the driver's discretion.

(5) Mount headlights meeting the following:

(a) Securely, at the front on a rigid part of the vehicle other than window glazing;

(b) As far apart and symmetrically about the vertical center line of the vehicle per FMVSS and SAE requirements;

(c) Measure mounting height from ground level to the center of the lens; and

(d) Mount headlights not less than 22 inches nor more than 54 inches high.

Stat. Auth.: ORS 184.616, ORS 815.030, ORS 816.010, ORS 816.040, ORS 816.050 & ORS 816.060

Stats. Implemented: ORS 816.010, ORS 816.050, ORS 816.060, ORS 816.070 & ORS 816.230

Disclaimer: These regulations may not be the most recent version. Oregon may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.