Oklahoma Administrative Code
Title 460 - Department of Mines
Chapter 20 - The Permanent Regulations Governing the Coal Reclamation Act of 1979
Subchapter 43 - Permanent Program Performance Standards: Surface Mining Standards
Section 460:20-43-40 - Backfilling and grading: thick overburden

Universal Citation: OK Admin Code 460:20-43-40

Current through Vol. 42, No. 1, September 16, 2024

(a) Definition. Thick overburden means more than sufficient spoil and other waste materials available from entire permit area to restore the disturbed area to its approximate original contour. More than sufficient spoil and other waste materials occur where the overburden thickness times the swell factor exceeds the combined thickness of the overburden and coal bed prior to removing the coal, so that after backfilling and grading the surface configuration of the reclaimed area would not:

(1) Closely resemble the surface configuration of the land prior to mining; or

(2) Blend into and complement the drainage pattern of the surrounding terrain.

(b) Performance standards. Where thick overburden occurs within the permit area, the permittee at a minimum shall:

(1) Restore the approximate original contour and then use the remaining spoil and other waste materials to attain the lowest practicable grade, but not more than the angle of repose;

(2) Meet the requirements of Sections 460:20-43-38(a)(2) through (j) of this Chapter; and

(3) Dispose of any excess spoil in accordance with Sections 460:20-43-24 through 460:20-43-27 of this Chapter.

Amended at 14 Ok Reg 3496, eff 8-11-97

Disclaimer: These regulations may not be the most recent version. Oklahoma may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.