Oklahoma Administrative Code
Title 230 - State Election Board
Chapter 35 - Election Conduct
Subchapter 3 - County Election Board Responsibilities
Part 13 - AFTER THE POLLS CLOSE
Section 230:35-3-85.3 - Removing election results storage device from voting device

Universal Citation: OK Admin Code 230:35-3-85.3

Current through Vol. 42, No. 1, September 16, 2024

Upon receipt of the voting device from the Inspector, County Election Board personnel immediately shall transfer the voting device to the designated secure work area for removal of the election results storage device. The following procedure shall be observed.

(1) Unlock and open the voting device case with the square key.

(2) Verify the seal number on the cover of the compartment containing the storage device against the Inspector's Notes to Secretary sheet. Cut and remove the seal.

(3) Unlock and remove the compartment cover with the square key.

(4) Remove the election results storage device.

(5) Verify that the correct precinct number is recorded on the storage device label.

(6) Transfer the election results storage device to the tabulation computer operator to be read and tabulated.

Added at 30 Ok Reg 1672, eff 7-15-13

Disclaimer: These regulations may not be the most recent version. Oklahoma may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.