North Dakota Administrative Code
Title 33.1 - Department of Environmental Quality
Article 33.1-15 - Air Pollution Control
Chapter 33.1-15-06 - Emissions of Sulfur Compounds Restricted
Section 33.1-15-06-04 - Continuous emission monitoring requirements

Universal Citation: ND Admin Code ยง 33.1-15-06-04

Current through Supplement No. 394, October, 2024

1. General provisions.

a. For sources subject to continuous emission monitoring requirements in their permit to operate, the monitoring systems must be used to demonstrate compliance with emission limits on a continuous basis after the initial compliance test and certification of the system.

b. Emission rates must be recorded in the units of the applicable standard. Conversion of monitor data to an emission rate expressed in pounds per million British thermal units [nanogram per joule] shall be calculated in accordance with the equations in section 33.1-15-06-03. Equations for calculating emission rates with different units will be supplied by the department.

2. Installation, operation, and certification. The installation operation, and certification of continuous monitoring systems and monitoring devices must comply with the provisions of 33.1-15-12 that apply to monitoring systems and monitoring devices.

3. Quality assurance. All continuous monitoring systems and monitoring devices must be recertified in accordance with the provisions of appendix B of 33.1-15-12 every three years unless otherwise directed.

General Authority: NDCC 23.1-06-04; S.L. 2017, ch. 199, § 1

Law Implemented: NDCC 23.1-06-08; S.L. 2017, ch. 199, § 21

Disclaimer: These regulations may not be the most recent version. North Dakota may have more current or accurate information. We make no warranties or guarantees about the accuracy, completeness, or adequacy of the information contained on this site or the information linked to on the state site. Please check official sources.
This site is protected by reCAPTCHA and the Google Privacy Policy and Terms of Service apply.