North Dakota Administrative Code
Title 24.1 - State Electrical Board
Article 24.1-02 - DEFINITIONS, GENERAL STATEMENT OF POLICY, AND INTERPRETATIVE RULES
Chapter 24.1-02-01 - GENERAL PROVISIONS
Section 24.1-02-01-01 - Definitions

1. "Correction order", also marked as FS, indicates a correction is necessary before installation will be considered approved by the board. It means a notice, written by an electrical inspector to the person responsible for the electrical installation, stating violations and noncompliance of rules and regulations as listed shall be corrected within a designated time.

2. "E-cert" is an electronic version of a wiring certificate.

3. "Kitchen" means an area where food is prepared that includes a sink and one or more permanent cooking appliances.

4. "Service" means the conductors and equipment for delivering electric energy from the serving source to the wiring system of the premises served.

5. "Service point" means the point of demarcation between the serving utility and the premises wiring. The service point is the point on the wiring system where the serving utility ends and the premises wiring begins. The serving utility generally specifies the location of the service point.

6. "Wiring certificate" means a document consisting of one or more copies that certifies electrical wiring and equipment was installed on premises and was done in strict compliance with all the provisions of North Dakota Century Code chapter 43-09 and all the requirements of the board.