North Carolina Administrative Code
Title 10A - HEALTH AND HUMAN SERVICES
Chapter 41 - EPIDEMIOLOGY HEALTH
Subchapter C - OCCUPATIONAL HEALTH
Section .0600 - ASBESTOS HAZARD MANAGEMENT PROGRAM
Section 41C .0605 - ASBESTOS CONTAINING MATERIALS REMOVAL PERMITS
Current through Register Vol. 39, No. 6, September 16, 2024
(a) No person shall remove more than 35 cubic feet (1 cubic meter), 160 square feet (15 square meters) or 260 linear feet (80 linear meters) of regulated asbestos containing material, without a permit issued by the Program. This permitting requirement is applicable to:
(b) All applications shall be made on a form provided or approved by the Program. The application submittal shall include at least all of the information specified under the notification requirements of 40 CFR Part 61.145(b), Subpart M as adopted in Rule .0609 of this Section. Applications for asbestos containing material removal permits shall adhere to the following schedule.
(c) Application for revision to an issued asbestos removal permit shall be made by the applicant in writing on a form provided by the Program and shall be received by the Program in accordance with the following:
(d) The following shall be maintained on site during removal activities and be immediately available for review by the Program:
(e) All permitted removal activities shall be conducted in accordance with 40 CFR Parts 61 and 763, Subpart E, where applicable.
(f) All permitted removals shall be conducted under the direct supervision of an accredited supervisor, except that permitted removals of roofing products may be conducted under the direct supervision of an accredited roofing supervisor. The supervisor or roofing supervisor, as applicable, shall be on-site at all times when removal activities are being performed. For the purpose of this Rule, removal activities for roofing products, means the tear off and disposal activities associated with these products, and does not include the roof replacement.
(g) An asbestos abatement design shall be prepared by an accredited abatement designer for each individually permitted removal of more than 3000 square feet (281 square meters), 1500 linear feet (462 meters) or 656 cubic feet (18 cubic meters), of regulated asbestos containing materials conducted in public areas.
(h) In accordance with G.S. 130A-23, the Program may suspend or revoke the permit for any violation of G.S. 130A, Article 19 or any of the rules of this Section. The Program may also revoke the permit upon a finding that its issuance was based upon incorrect or inadequate information that materially affected the decision to issue the permit. Notwithstanding permit suspension or revocation for violation of the rules of this Section, an asbestos removal permit shall also be subject to suspension or revocation if the removal activities are in violation of the following provisions with regard to asbestos abatement, as determined by the agencies which administer these Rules:
(i) All waste shipment records shall be submitted to the Program by the building owner or a representative of the owner for all asbestos removal projects permitted under this Rule. This submittal shall be made on a form provided or approved by the Program. This form shall include at least all of the information specified under the waste shipment record requirements of 40 CFR Part 61, Subpart M, Section 61.150(d) as adopted in Rule .0609 of this Section.
(j) The following schedule shall be adhered to in the submittal of waste shipment records:
Authority
G.S.
130A-5(3);
130A-449;
P.L.
99-519;
Temporary Rule Eff. November
1, 1989 for a period of 180 days to expire on April 30, 1990;
Eff.
February 1, 1990;
Amended Eff. October 1, 1994; August 1,
1991;
Temporary Amendment Eff. November 8, 1994 for a period of 180
days or until the permanent rule becomes effective, whichever is
sooner;
Amended Eff. July 1, 1996; January 1, 1995;
Pursuant to
G.S.
150B-21.3A, rule is necessary without
substantive public interest Eff. February 16,
2019.